Sega TOP SKATER User manual

OWNER’SMANUAL
SEGA ENTERPRISES, USA
MANUAL NO. 4201-6308-01
1ST PRINTING
MAY 1997
TM

Warranty
Your new Sega Product is covered for a period of 90 days from the date of shipment. This certifies
that the Printed Circuit Boards, Power Supplies and Monitor are to be free of defects in workman-
ship or materials under normal operating conditions. This also certifies that all Interactive Control
Assemblies are to be free from defects in workmanship and materials under normal operating condi-
tions. No other product in this machine is hereby covered.
Sellers sole liability in the event a warranted part described above fails shall be, at its option, to
replace or repair the defective part during the warranty period. For Warranty claims, contact your
Sega Distributor.
Should the Seller determine, by inspection that the product was caused by Accident, Misuse, Ne-
glect, Alteration, Improper Repair, Installation or Testing, the warranty offered will be null and void.
Under no circumstances is the Seller responsible for any loss of profits, loss of use, or other dam-
ages.
This shall be the exclusive written Warranty of the original purchaser expressed in lieu of all other
warranties expressed or implied. Under no circumstance shall it extend beyond the period of time
listed above.

INTRODUCTION OF THE OWNERS MANUAL
GENERAL PRECAUTIONS
1. PRECAUTIONS TO BE HEEDED FOR OPERATION
2. NAME OF PARTS
3. ACCESSORIES
4. ASSEMBLYAND INSTALLATION
5. PRECAUTIONS TO BE HEEDED WHEN MOVING MACHINE
6. CONTENTS OF GAME
7. EXPLANATION OF TESTAND DATA DISPLAY
7-1 POWER SUPPLY UNIT AND COIN METER
7-2 TEST MODE
7-3 MEMORY TEST
7-4 INPUT TEST
7-5 OUTPUT TEST
7-6 SOUND TEST
7-7 C.R.T. TEST
7-8 GAME ASSIGNMENTS
7-9 COIN ASSIGNMENTS
7-10 BOARD SETTING
7-11 BOOKKEEPING
7-12 BACKUP DATA CLEAR
8. MAINTENANCE OF MECH UNIT
8-1 ADJUSTMENTAND REPLACEMENT OF SLIDE VOLUME
8-2 ADJUSTMENTAND REPLACEMENT OF CURVING VOLUME
8-3 GREASING
8-4 REPLACEMENT OF HAZARD PREVENTIVE PARTS
9. COIN SELECTOR
10. PROJECTOR
10-1 CLEANING THE SCREEN
10-2 MITSUBISHI MONITOR
11. REPLACEMENT OF FLUORESCENT LAMPAND LAMPS
11-1 REPLACEMENT OF FLUORESCENT LAMP
11-2 REPLACEMENT OF LAMPS
12. PERIODIC INSPECTION TABLE
13. TROUBLESHOOTING
13-1 REPLACEMENT OF FUSES
14. GAME BOARD
14-1 REMOVING THE IC BOARD
14-2 COMPOSITION OF THE GAME BOARD
15. DESIGN RELATED PARTS
16. PARTS LIST
17. WIRING CODE COLOR TABLE
18. WIRING DIAGRAMS
1
2~3
4~6
7
8
9-19
20
21~25
26~39
27
28
28
29~30
29~30
31
31
32
33~35
36~37
38
39
40~42
40
41~42
42~44
45
46~47
48~51
48
49~51
52
52
52
53
54~55
55
56
56
57
58~59
60
103
XXX
TABLE OF CONTENTS

1
SPECIFICATIONS
Installation space: 106.5 in.(L) x 46 in.(W)
Height: 89 in.
Weight: Approx. 963 lbs.
Power maximum current: 7 Amp AC 120V 60 Hz
MONITOR: 50 INCH PROJECTION DISPLAY
SEGA ENTERPRISES, LTD., has for more than 30 years been supplying various innovative and
popular amusement products to the world market. This Owners Manual is intended to provide
detailed descriptions together with all the necessary installation, game settings and parts ordering
information related to the TOP SKATE, a new SEGA product.
This manual is intended for those who have knowledge of electricity and technical expertise, espe-
cially in ICs, CRTs, microprocessors, and circuit boards. Read this manual carefully to acquire
sufficient knowledge before working on the machine. Should there be a malfunction, non-technical
personnel should under no circumstances touch the interior system. Should the need arise, contact
our main office, or the closest branch office listed below.
SEGA ENTERPRISES, INC. (USA)
Customer Service
45133 Industrial Drive
Fremont, CA 94538
Phone [phone]
Fax [phone]
7:30 am - 4:00 pm, Pacific Standard Time
Monday thru Friday
INTRODUCTION OF THE OWNERS MANUAL

2
General Precautions
Follow Instructions:All operating and use instructions should be followed.
Attachments: Do not use attachments not recommended by the product manufacturer as they may cause hazards.
Accessories: Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall,
causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket, or
table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the
manufacturer’s instructions, and should use only mounting accessories recommended by the manufacturer.
Moving the Product: This product should be moved with care. Quick stops, excessive force, and uneven surfaces
may cause the product to overturn.
Ventilation: Slots and openings in the cabinet are provided for ventilation, to ensure reliable operation of the product
and to protect it from overheating; these openings must not be blocked or covered. The openings should never be blocked by
placing the product in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the
manufacturer’s instructions have been adhered to.
Power Sources: This product should be operated only from the type of power source indicated on the marking label.
If you are not sure of the type of power supply to your location, consult your local power company. For products intended
to operate from battery power or other sources, refer to the operating instructions.
Grounding or Polarization: This product is equipped with a three-wire grounding-type plug, a plug having a third
(grounding) pin. This plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to
insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the
grounding-type plug.
Power Cord Protection: Power-supply cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point
where they exit from the product.
Overloading: Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in
a risk of fire or electric shock.
Object and Liquid Entry: Never push objects of any kind into this product through openings as they may touch
dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the
product.
Servicing: Do not attempt to service this product yourself as opening or removing covers may expose you to danger-
ous voltage or other hazards. Refer all servicing to qualified service personnel.
Damage Requiring Service: Unplug this product from the wall outlet and refer servicing to qualified service person-
nel under the following conditions:
a) If the power cord or plug is damaged;
b) If liquid has been spilled, or objects have fallen into the product;
c) If the product has been exposed to rain or water;
d) If the product does not operate normally when following the operating instructions.Adjust only those controls that
are explained in the operating instructions.An improper adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to restore the product to its normal operation;
e) If the product has been dropped or damaged in any way;
f) When the product exhibits a distinct change in performance; this indicates a need for service.
Replacement Parts: When replacement parts are required, be sure the service technician has used replacements parts
specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may
result in fire, electric shock, or other hazards.

3
Safety Check: Upon completion of any service or repairs to this product, ask the service technician to perform safety
checks to determine that the product is in proper operating condition.
Heat: The product should be situated away from heat sources such as radiators, heat registers, stoves, or other prod-
ucts (including amplifiers) that produce heat.
Lithium Battery- Dispose of batteries only in accordance with the battery manufacturer’s recommen-
dations. Do not dispose in an open flame condition, since the battery may explode.
Cleaning: When cleaning the monitor glass, use water or glass cleaner and a soft cloth. Do not apply chemicals such
as benzine, thinner, etc.
Location: This an indoor game machine, DO NOT install it outside.To ensure proper usage, avoid installing indoors
in the places mentioned below:
• Places subject to rain/water leakage, or condensation due to humidity;
• In close proximity to a potential wet area;
• Locations receiving direct sunlight;
• Places close to heating units or hot air;
•In the vicinity of highly inflammable/volatile chemicals or hazardous matter;
• On sloped surfaces;
• In the vicinity of emergency response facilities such as fire exits and fire extinguishers;
• Places subject to any type of violent impact;
• Dusty places.
INSTALLATION PRECAUTIONS
• Verify the amperage of the branch circuit outlet before plugging in the power plug. Do not over-
load the circuit.
• Avoid using an extension cord. If one is required, use an extension cord of type SJT, 16/3 AWG
rated min. 120 VAC, 7A.
• Moving this unit requires a minimum clearance (of doors, etc.) of 32” (W) by 77” (H).
• For the operation of this machine, secure a minimum area of 32” (W) by 42”(D).
REGULATORY APPROVALS
This game has been tested and found to comply with the Federal Communications Commission Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This game has been tested and listed by Underwriters Laboratories, Inc., to ANSI/UL22.
LISTED
UL
®
5K92
AMUSEMENT MACHINE

4
In order to avoid accidents, check the
following before starting the operation:
Check if all of the adjusters are in
contact with the surface. If they are
not, the cabinet can move and cause
an accident.
Check to see if hazard
preventive parts are
damaged or omitted.
Operating the product
with the hazard preven-
tive parts as is left in an
irregular status will
cause accidents.
Do not put any heavy item on this product. Placing any heavy item on the
product can cause a falling down accident or parts damage.
Do not climb on the product. Climbing on the product can cause falling
down accidents. To check the top portion of the product, use a step.
To avoid electric shock, check to see if door & cover parts are 508.5
To avoid electric shock, short circuit and or parts damage, do not put the
following items on or in the periphery of the product:
Flower vases, flower pots, cups, water tanks, cosmetics, and receptacles/
containers/vessels containing chemicals and water.
1 . PRECAUTIONS TO BE HEEDED FOR OPERATION
PRECAUTIONS TO BE HEEDED FOR OPERATION BEFORE STARTING THE OPERATION
This product allows the game to be played by operating the SKATE BOARD. In order to prevent
accidents, be sure to comply with the following points before and during operation.
To avoid injury, be sure to provide sufficient space by considering the
potentially crowded situation at the installation location. Insufficient instal-
lation space can cause the player to come into contact with or hit the
others and result in injury or trouble.

5
PRECAUTIONS TO BE HEEDED DURING OPERATION
To avoid injury and trouble, be sure to constantly give careful attention to the behavior and manner of the
visitors and players.
To avoid injury and accidents, those who fall under the following catagories are
not allowed to play the game.
> Intoxicated persons.
> Pregant women or those who are in the likelihood of pregnancy.
> Those who need assistance such as the use use of apparatus when walking.
> Those who have high blood pressure or a heart condition.
> Those who have experienced muscle convulsion or loss of conciousness when
exposed to intensive light stimulus due to watching television, playing video
games or water surface flickering.
> Persons susceptible to motion sickness.
> Persons whose actions runs counter to the product’s warning displays.
The player should be able to get on the
skate board and hold on firmly to the
safety bar. To avoid falling down accidents,
instruct those who are shorter than 51
inches not to play, as the height of the
saftey bar is approximately 51 inches.
Instruct those who
wear high heel shoes to
refrain from playing the
game by explaining that
playing game with high-
heeled shoes is very
likle to cause poten-
tially hazardous situa-
tion.
To avoid injury from potential falling
down accidents, be sure to that only
one person is allowed to play at a time.
Do not allow players to put any
heavy items or beverages on the
product. Falling items can cause
accidents and spilled beverages
can cause electric shock.
To avoid electric shock and short circuit, do not allow customers to put hands
and fingers or extraneous matter in the openings of the product or small open-
ings in or around the doors.
To avoid falling down and injury resulting from falling down, immediately stop the
customer’s leaning against or climbing on the product, etc.
To avoid electric shock and short circuit, do not allow the customers to unplug
the power plug without justifiable reason.

6
Instruct the player to hold firmly to the Saftey Bar during game. Caution
the customers who are most likely to cause injury by playing without
holding the Safety Bar, for example.
To avoid injury, do not allow
persons other than the player
access to the mechanism base
during game play.
Instruct the player to play by
standing on both feet. Standing
on one leg to play can cause
injury.
Instruct the player not to put
baggages, etc. on the mechanism
base to avoid damaging such
items.
Regarding this product, the
weight of the player is limited to
330 lbs. To avoid machine dam-
age and injury due to machine
damage, playing by those who
are as heavy as 330 lbs. or
heavier is strictly prohibited.
Immediately stop violent acts such as hitting and kicking the product. Such
violent acts can cause parts to be damaged or falling down, resulting in injury
due to fragments and falling down.

7
2 . NAME OF PARTS
PTV
REAR CABI
BILLBOARD
GAME SPECIFICATIONS
REAR CABINET
PTV
WHEN ASSEMBLED
REAR CABINET
PTV BASE/BILLBOARD
WIDTH LENGTH HEIGHT WEIGHT
DURING SHIPPING
963 LBS.
158.5 LBS.
263 LBS.
33 LBS.
508.5 LBS.
387 LBS.
FIG.2 OVERVIEW
CONTROL PANEL
CASHBOX DOOR
COIN CHUTE DOOR
SKATE BOARD
CAUTION MAT
ASSY TUBE
PTV BASE
SAFETY BAR
MECHANISM BASE
ASSY TUBE
AC UNIT
ASSY TUBE
BILLBOARD
PTV BASE
PTV 462 LBS.
748 LBS.
1597 LBS.
All measurements are in inches
63” X 44.5” X 64”
55” X 37.5” X 77”
54” X 48” X 43.5”
46” X 18” X 12”
38” X 58” X 56”
46” X 22” X 67”
47” X 41” X 31.5”
47” X 108” X 90”