Seville Classics SHE05122 User manual

Thank you for choosing Seville Classics! We hope that you enjoy your
new double-basket cabinet organizer. Please read through this user
guide for parts list, assembly instrucons, frequently asked quesons
and further contact informaon.
Stackable 3-Tier Sliding Double Basket
Cabinet Organizer /w Bonus Liners
Customer Service Informaon
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email: [email protected]
Homepage: www.SevilleClassics.com
FAQs
Q. Does this stack with other Seville Classics Organizers?
A. No. This model is only compable with other SHE05122 units.
Q. How big is it?
A. Dimensions measure 17.5" D x 11.5" W x 18.5" H.
Q. How much can it hold?
A. 5 lbs. (2.2 kgs) per basket and 15 lbs. (6.8 kgs) on the top shelf.
Model #: SHE05122
08-2017
08-2017
STEP 5. Fit LINERS (E) into the base of the
SHALLOW BASKET (G), DEEP BASKET (H),
and the SHELF (F).
Insert baskets into channels when nished.
Stacking (oponal)
Remove LEVELING FEET (I) and screw in
STACKING PINS (J).
Pry pole caps from exisng organizer.
Align stacking pins with pole holes on
exisng organizer and press down.
Do not stack more than 2 units

Parts List
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at [phone]
or send an email to [email protected]
Assembly Instrucons
A. Poles (4)
B. Crossbars (2)
C. Drawer Guides (4)
D. Slip Sleeve Pairs (16)
E. Liners (3)
F. Shelf
G. Shallow Basket
H. Deep Basket
I. Leveling Feet (4)
J. Stacking Pins (4)
TIP: When assembling the slip
sleeves, make sure the arrow on
each half is poinng upward
towards the top of the pole.
Otherwise they will not t correctly.
STEP 1. Screw LEVELING FEET (I) into POLES (A).
STEP 3. Clip a pair of SLIP SLEEVES (D) around the
middle set of double grooves on each POLE (A).
Make sure DRAWER GUIDES (C) are closed on the
same end, then slide DRAWER GUIDES over the
POLES and SLIP SLEEVES and press down rmly.
Repeat for next highest set of double grooves.
STEP 4. Clip a pair of SLIP SLEEVES (D) around the
top grooves on each pole. Slide SHELF (F) over the
poles and press down rmly.
12
STEP 2. Clip a pair of SLIP SLEEVES (D) around
boom level of grooves on POLES (A).
Slide a CROSSBAR (B) over a pair of POLES (A) and
press down rmly. Repeat for other pair.