ShoreStation Lakefront Systems User manual

Doc Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorestation.com 0004441
Page 1 of 2 Rev 3.4
S H O R E S T A T I O N L A K E F R O N T S Y S T E M S
ShoreStation Hydraulic Wireless Pairing Instructions
Pair the wireless controllers with the lift controller.
o Unlock the key fobs.
o Turn the lockout key to the ON position.
o Trip the top limit switch 10 times in less than 30 seconds. The light 1 output should
flash once to indicate it is in pairing mode. This process is the same for when no upper
limit switch is installed and the jumper wire is installed. Pull the plug apart, slide one
side in until a connection is made then tap other connection 10 times.
o Press the UP or DOWN button on the wireless control once. The Light 1 output
should flash once to indicate it paired with the wireless control. Repeat for the other
controller.
o The Light 1 output should flash 2 times after a few seconds to indicate it is no longer
in pairing mode.
o Test the wireless controllers to see if they run the lift. If not, the wireless controls may
need to be replaced.

Doc Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorestation.com 0004441
Page 2 of 2 Rev 3.4
S H O R E S T A T I O N L A K E F R O N T S Y S T E M S
ShoreStation Power Winch Wireless Pairing Instructions
Step 1 –Unlock the remote control
Press and hold up and down buttons on the new remote control until the
mode one light blinks.
Step 2 –Set the receiver into ‘program mode’
Press and hold the programming button located on the lift controller until it
beeps once.
Electric controllers are located inside the winch case. You may need to remove one mounting bolt from the receiver to gain
access to the programming button. If you have trouble pressing the button, a pointed object (ball point pen) can be pressed
into the button.
Step 3 –Program the remote control
Press the UP/ON button on the new remote control. The controller should beep again indicating that the new fob is now
programmed to work with the system. Repeat this step for any other remote controls. The controller will beep twice when it
has reached its maximum ten of 10 remote controls. The remote controls should now operate the lift.
WARNING: Never program one remote control to run more than one lift in the same mode. Doing so could cause
unintended operation of the lift and result in serious injury.
To cause the receiver to ‘forget’ a remote control, repeat the programming instructions and program only the intended remote
controls for the lift. Continue to press the button of the last remote control until the controller double-beeps. It should now be
programmed only for these fobs.
Figure 1: Electric Controller
Programming
Button
•Never pair a remote control with
more than one lift system.
•Remove the boat from the lift
when performing the pairing
process.
•Wear personal protective
equipment (safety glasses, gloves,
etc.) when performing this
process.
Safety Instructions