Signature Hardware Engel Tempered Glass Shelf User manual

ENGEL TEMPERED GLASS SHELF INSTALLATION
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing this type of product. Signature
Hardware accepts no liability for any damage to the
product, mounting surface, or for personal injury during
installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage. If
any damage is found, contact our Customer Relations
team at 1-866-855-2284.
Ensure that you have gathered all the required
materials that are needed for the installation.
TOOLS AND MATERIALS:
Phillips
Screwdriver
1Engel Tempered Glass Shelf Installation Instructions
Pencil
Tape Measure Level
Flathead
Screwdriver
Drill
SKU(s): 916693

ENGEL TEMPERED GLASS SHELF INSTALLATION
INSTALLATION
2Engel Tempered Glass Shelf Installation Instructions
1. Before you begin, attach the front rail to the glass
shelf, as shown.
corner
corner
2. Hold the shelf at the desired installation location.
Using a level and a pencil, draw a straight light line on
both walls along both edges of the shelf.
4. Drill a pilot hole into the marked locations from step
3. Insert the provided anchors into each hole. Once
anchors are installed, erase all pencil makings from the
wall. Important: If drilling through tile, ensure that you use a
masonry drill bit and drill slowly to avoid cracking.
3. If installing the 11” version, measure 4” from the
corner along each line marked in step 2. For the larger
14“ version, measure 5”. Mark these locations on each
line using a pencil.
corner
4-5” 4-5”

ENGEL TEMPERED GLASS SHELF INSTALLATION
3Engel Tempered Glass Shelf Installation Instructions
corner corner
5. Attach the mounting brackets to the installed
anchors using the provided screws.
6. Slide the glass shelf into the installed mounting
brackets. Tighten the set screws underneath to
secure and finish the installation.