SIHOO H6C User manual

!
At t ent ion, only adult s are allow ed t o inst all,
children ot allow ed!
Dimension：10 0 * 6 6 *8 3 (10 6 )CM
INSTALLATION GUIDE
KIDS STUDY FURNITURE
are n
H6C

Installation diagram （Follow the actual size）
3 4
1 2
1.Screw out the fixings metal at both ends;
2.Insert the hexagon strip into the hexagon hole of the
left and right table legs(When passing through one of
them,the legs pass through the fixings metal at the
same time;)
3.push the fixings metal to both sides and tighten.
Put 4 taper nuts into the table leg link board,and
then use 4 screws M6*30 tighten to the taper
nut(Note: the hole of the table leg link board is
facing forward).
Note：the pasted side of
the table leg faces out.
Use 8 ScrewsM6*14 to install the left and right
table legs on the table board (Keep the table leg
and handle in the same direction).
Note:the pasted
side of the table
leg faces out.
Install the playwood to the shelf back panel with 2
screws and lock handles.
7 8
5 6
1.Install the left and right outer panels with
screws;
2.Install the left and right outer boards to the
bookshelf backboard and large plywood;
3.Tighten each lock handle.
Use 4 screws M6*14 to install the left and right
bookshelf corners on the bookshelf side panel
and tighten.
Put the bookshelf on the desktop and tighten the
bookshelf knob.
1.Use two M4 * 10 screws to install the hook on the
desktop component;
2.Put 2 rubber plugs into the rocker hole, and the
table installation is completed;
(warm tip: when the table needs to be adjusted by
lifting, first take out the rubber plug,then put the
lifting adjustable into the hole)
Warm tip: after the table is installed, please attach the back of
the bookshelf to the wall and install the anti overturning device.

Installation diagram of anti-overturning device
(According to the actual size)
Note: use a 8mm diameter impact drill.
1. Install the anti overturn device in the proper position of the table.
2. Install locating piece under L-shaped panel of table.
3. Drill the holes in the right places on the wall.
4. Insert the plastic part into the hole.
5. Install the locating piece to the plastic part with screws.
6. Finally lock the table on the locating panel with elastic belt.
7. Install an anti overturning device on the left and right respectively.
Wall
×4 ×4
3.5*14 Screws
×4
×2
elastic belt lastic belt
with base 8MM Rubber plug
×4
3.5*40 Screws
Accessories list
Here please use
4cm screws.
Here please use 1.4cm screws.
Note:
(Read the tips carefully and use the product safely)
Attention! Only adults are allowed to install, and children
are not allowed to close.
Applicable age:3 years and above.
Danger!Please do not lift up and down and play frequently!
The height of the table is 53-76cm,and the height is limited.Do
not exceed the scale on the side of the table foot when adjusting.
It’s dangerous.Do not stand on the table or use it as a step
or ladder.
The bookshelf can be removed by unscrewing the knob!
Do not sit or press on the table and drawer,do not put
heavy things!
Please put it on flat ground when using!
Warning!Be careful of pinching!
KG