Sinbo SHD 7046 User manual

SHD 7046 HAIR STRAIGHTENER, CURLER AND CRIMPER
INSTRUCTION MANUAL
EN
RU

- 1 -
ENGLISH
SINBO SHD 7046
HAIR STRAIGHTENER, CRIMPER, CURLER 3 IN 1
INSTRUCTION MANUAL
SAFETY INSTRUCTIONS AND WARNINGS
• Read these instructions carefully before putting the appliance into operation and keep
them in a safe place for future consultation.
• This appliance is only for domestic use, not industrial use.
• Do not leave the appliance connected and unattended when not in use. Moreover, this
will allow saving energy and extending the life of the appliance.
• Do not leave the appliance within the reach of children or disabled individuals.
• Before connecting the appliance to the mains, check that the voltage indicated on the
nameplate coincides with the mains voltage.
• Do not use the appliance near the shower, bath or other containers holding water.
• Keep the appliance out of the reach of children.
• Do not use the appliance on wet hair.
• Do not use the appliance if the cable or plug are damaged, or if not functioning correctly.
• Do not throw or insert anything into any of the appliance’s cavities.
• Do not leave the appliance switched on top of any surface.
• The appliance heats when in operation. Do not bring the hot parts into contact with the
skin to avoid burns.
• Never leave the appliance connected to the socket.
• Never put the appliance away when it is still hot or connected.
• Never wrap the cable around the appliance when it is still hot.
INSTRUCTIONS FOR USE
• Connect the appliance to a socket.
• The hair straightener has a built-in ceramic PTC system to keep the temperature of
the ceramic plates constant.
Press lock to outside position, this is for hair straightener function.
Press lock to middle position, this is for hair curler function.
Press lock to inside position, this is for hair crimper function.
• In order to straighten hair perfectly, take a strand which is not too thick.
• Starting at the root, place it between the plates in a perpendicular position and gently
pull downwards until reaching the ends of the strand.
If necessary, repeat this action various times.
• Apply the same technique to the rest of the hair.
• When finished, disconnect the appliance by putting the switch in the stop position and
unplug it from the socket.

- 2 -
PROBLEMS AND SOLUTIONS
Should the mains connection fail, do not try to replace it since this is potentially dangerous.
Take the appliance to an authorized Technical Support Service. The same applies to
another type of problem.
TECHNICAL DETAILS
- Power supply: AC230V, 50Hz
- Power: 55W
- Ceramic coating barrel
- PTC heater
- Switch on/off
- 360 degree swivel cable

- 3 -

- 4 -

- 5 -

- 6 -
12-2020