SKF VIBRACON User manual

SKF Vibracon
re-adjustable steel chock
Benefits:
• Eliminate the “Soft Foot”
• Save installation time
• Self leveling
• Re-adjustable / re-useable
• Chock fast, no curing
• No special installation skills required
Quick start guide
13. OEM bolt tightening sequence
Bolt tightening advice:
A. 25% of tightening torque
B. 50% of tightening torque
C. 100% of tightening torque
Check with OEM
Bolt tightening advice:
Re-check after 24 hot running hours
Remove complete or lock, with a locking nut,
the released adjustment bolts.
14. Release horizontal adjustment bolts
® SKF is a registered trademark of the SKF Group.
© SKF Group 2019
The contents of this publication are the copyright of the publisher
and may not be reproduced (even extracts) unless prior written
permission is granted. Every care has been taken to ensure the
accuracy of the information contained in this publication but no
liability can be accepted for any loss or damage whether direct,
indirect or consequential arising out of the use of the information
contained herein.
PUB 43/P2 16115/2 EN · December 2019
✓
15. Check the final alignment
16. Recommendations
1
2
34
vibrac[email protected]om
skf.com/vibracon
Related products
Vibracon selection tool:
mapro.skf.com/vibracon
Contact details:
SKF Spherical washers
SKF Shaft alignment tools
Surface treated SKF Vibracon chocks SKF Vibracon low profile chock
and spherical washer
✓
✓
✓

2. Adjustment of the component
4. Installation check
1. Alignment check of the component
3. Outcome of the adjustment: gaps to fill
6. Installation of the SKF Vibracon
8. Installation of bolts
5. Foundation check
7. Batch number in sight/front for traceability
9. Adjustment to height
10. Check contact area
11. Check maximum height
12. Release vertical adjustment bolts
✓
✓✓ ✓
✓✓
✓ ✓
✓
✗
✓
✓