SolaX Power X-Hybrid SK-BMU User manual

-Mark the position of the 4 holes -Tighten the expansion tubes.
-Screw the expansion screws.
-Connect BUS connector to BUS port on the BMU.
-Connect the other side to BUS port on the inverter.
-Match the BMU with the bracket.
-Drill holes with φ6 drill
-Depth：at least 50mm.

-Insert RJ45 side of CAN connector into CAN port
on the inverter.
-Insert the other side into CAN port on the BMU.
Find battery communication cable
in battery packing.
- Insert RJ45 side of cable into the
BMS cinnector on the inverter.
- Connect the other side to RS232
on the battery.
- Insert Battery connector to BAT port on the BMU.
- Insert Battery connector to port on the battery.
- Insert RJ45 side of thermal sensor connection cable into
the TEMP port on the inverter .
- Connect the other side of thermal sensor with the
negative power pole on the battery.
-Tighten the screw of earthing connector clockwise.
614.00058.01