SOMFY RAINER MAESTRIA 50 RTS Operating instructions

1
FACTORY MODE
BEFORE YOU BEGIN
Motors are shipped in FACTORY MODE without limit settings and the
transmitter ID’s. Power must ONLY be connected to current screen
being programmed. All other screens must be disconnected from their
respective power while programming.
Note - If motor is 120V AC hardwired and cannot be disconnected,
please contact an electrician prior to calling Somfy customer service
for assistance.
UICK PROGRAMMING GUIDE FOR
MAESTRIA™ 50 RTS MOTORS
CONNECT TO POWER MODE
With the motor installed in the screen, connect power to the motor (120V AC).
While programming, screens should not be inactive for longer than 2 minutes
or motor will exit PROGRAMMING MODE.
Side View
50mm motor diameter
INITIATE PROGRAMMING
On the transmitter, press and hold both UP and DOWN
simultaneously until the screen jogs.
CHECK THE DIRECTION OF OPERATION
If hand-held transmitter direction is not properly programmed,
Eolis/Soliris RTS sensor will not function in the manner it was
intended. Damage to the screens and injury may occur as a result.
Check the direction of rotation by pressing UP or DOWN.
If necessary change the direction of rotation by simply
pressing and holding the MY button until the screen jogs.
MAESTRIA™ 50 RTS
MOTORIZATION FOR EXTERIOR SCREENS

2
UICK PROGRAMMING GUIDE FOR
MAESTRIA™ 50 RTS MOTORS
PROGRAMMING MODE
MANUAL ADJUSTMENT OF THE UPPER END LIMIT AND
THE LOWER END LIMIT
1) Position the screen at the desired UPPER Limit
2) Press MY and DOWN simultaneously:
the screen lowers.
3) Position the screen at the desired
LOWER Limit.
4) Press MY and UP simultaneously:
the screen raises.
5) Press MY until the screen jogs to
validate the end limit setting.
6) Flip the remote over and push the program button
on the back until the screen jogs to finalize the
programming

3
UICK PROGRAMMING GUIDE FOR
MAESTRIA™ 50 RTS MOTORS
OBSTACLE DETECTION
CHOICE OF THE LEVEL OF DETECTION
his function gives the possibility to adjust the obstacle detection
during the downward movement to deactivate it or adjust the
sensitivity.
1) Starting from the screen in half-way position, press MY and UP briefly and again
MY and UP for 2 seconds. The screen jogs.
ESD level 0: the obstacle detection is more sensitive. The
screen moves up and down slowly.
ESD level 1: (DEFAULT) - the obstacle detection is reliable
on most zip screens. The screen jogs.
The Factory default is OK for Tall Hem Bar (unless narrow
opening).
For short hem bar units, put the motor in more sensitive
mode (ESD level 0).
ESD level 2: the obstacle detection is deactivated. The
screens moves up and down slowly.
3) Press MY for 2 seconds to validate the setting.
The screen jogs.
2 sec.
2) Within 10 seconds press UP or DOWN to change the level of detection.
(without feedback within 10 seconds the actuator goes back to USER MODE.
Go back to Step 1.)
2 sec.
Slow jog
Slow jog
Short jog