9GB
Getting StartedGetting Started
Sub woofer
Initial setting is : SUB WOOFER [YES]
• If you connect a sub woofer, select “YES” to output
the LFE (low frequency extension) channel from the
sub woofer.
• If you do not connect a sub woofer, select “NO”. This
activates the Dolby Digital (AC-3) bass redirection
circuitry and outputs the LFE signals from other
speakers.
• In order to take full advantage of the Dolby Digital
(AC-3) bass redirection circuitry, we recommend
setting the sub woofer’s cut off frequency as high as
possible. (However, when using an amplifier with 5.1
ch inputs, set the sub woofer’s cut off frequency to
match the characteristics of the amplifier.)
4Use digital processing control buttons ( / ) to
adjust the level of the parameter.
Adjusting the delay time
The delay time allows you create a more effective
surround effect by adding a sense of depth to the
centre or rear channels. Longer delay times create a
greater sense of depth.
1Press POWER on the front panel to turn on the
processor.
2Press DPC MODE repeatedly until “OTHER
SETUP” appears in the display
3Use digital processing control buttons ( / ) to
select the parameter you want.
Centre speaker delay
Initial setting is : CENTER DELAY 0ms
Use this parameter to add a sense of depth to the centre
channel.
• Centre speaker delay time can be set in 1 ms steps
from 0 to 5 ms.
Rear speaker delay
Initial setting is : REAR DELAY 5ms
Use this parameter to add a sense of depth to the rear
channels.
When “PRO LOGIC” is displayed, the actual delay time
is 15ms longer than the time shown in the display.
• Rear speaker delay time can be set in 5 ms steps from
0 to 15 ms.
4Use digital processing control buttons ( / ) to
adjust the level of the parameter.
Adjusting the speaker volume
Use the remote while seated in your listening position
to adjust the volume of each speaker.
Note
This unit incorporates a new test tone with a frequency
centreed at 800 Hz for easier speaker volume adjustment.
1Press TEST.
You will hear the test tone from each speaker in
sequence.
2From your listening position, use the remote to
adjust the volume of each speaker so that the test
tone can be heard at the same level from all
speakers.
APress FRONT BAL L or R to adjust the balance
between the front left and right speakers (±8
dB, 0.5 dB/steps).
During this adjustment, the test tone is emitted
from both speakers simultaneously.
BPress REAR BAL L or R to adjust the balance
between the rear left and right speakers (±8 dB,
0.5 dB/steps).
During this adjustment, the test tone is emitted
from both speakers simultaneously.
CPress CENTER + or – to adjust the level of
centre speaker (+10 to –20 dB, 0.5 dB/steps).
During this adjustment, the test tone is emitted
from the centre speaker.
DPress REAR + or – to adjust the level of rear
speakers (+10 to –20 dB, 0.5 dB/steps).
During this adjustment, the test tone is emitted
from both speakers simultaneously.
EPress SUB WOOFER + or – to adjust the level
of the sub woofer (+10 to –20 dB, 0.5 dB/steps).
During this adjustment, the test tone is emitted
from the sub woofer.
3Press TEST to turn off the test tone.
(continued)
1, 3
MASTER
VOLUME
2 A
2 B
2 C
2 D
2 E
