Southern Enterprises MS990600TX User manual

For assistance with assembly contact:
Southern Enterprises Inc.
Customer Service 1-800-6 -5096
[email protected]
www.seidal.com
“Antebellum” TV/Media Stand
MS990600TX -Antique White
MS991600TX-Black
MS992600TX-Black/Walnut
Assembly Instructions
PO
:

A
“Antebellum” TV/Media Stand
Parts List
Please review all parts and hardware before disposing of any packaging.
Call Customer Service if missing hardware.
Using hardware that is too long will cause damage.
Before beginning assembly, separate each type of hardware. Carefully study the hardware
diagrams below. You may receive extra hardware with your unit
B C
Quantity
of 1
Quantity
of 1
Bottom Base
Side Adjustable Shelf
Middle Adjustable Shelf
Quantity
of 1
Right Side Panel
Left Side Panel
Left Middle Panel
Left Door
Right Middle Panel
Right Door
Back Panel
Top Panel
D
E
F
Quantity
of 1
Quantity
of 1
Quantity
of 1
G H I
Quantity
of 1
Quantity
of 1
Quantity
of 1
J
K
Quantity
of 2
Quantity
of 1

“Antebellum” TV/Media Stand
Parts List
Please review all parts and hardware before disposing of any packaging.
Call Customer Service if missing hardware.
Using hardware that is too long will cause damage.
Before beginning assembly, separate each type of hardware. Carefully study the hardware
diagrams below. You may receive extra hardware with your unit
Assembly Tool Required
No. 2 Phillips Screwdriver
(1)
8mm x 0 mm
Wood Dowel
Quantity
of 16
1/4” x 1” Bolt
(2)
Quantity
of 2
5/ 2” x 22mm
Bolt For Wood Knob
Assembly Tool Required
No. 2 Phillips Screwdriver
(Not Included)
Care and Cleaning In truction :
Before using, wipe with a clean, dry cloth.
Periodically apply furniture wax to renew
the finish. Avoid rubbing or scratching the
surface with rough or abrasive objects.
For replacement parts or questions, please
call Customer Service at 1-800-6 -5096.
Please call manufacturer for assistance,
questions or parts.
Quantity
of 22
Wood Knob
.5mm x 15 mm
Screw For Magnet
.5mm x 15 mm
Screw For Bracket
( )
(4)
(5)
(6)
(7)
(8)
Quantity
of 16
Quantity
of 2
Quantity
of 12
Quantity
of 2
Quantity
of 4
.5mm x 12 m
m
Screw For Back
Magnet
Quantity
of 4
(10)
Metal Pin
(9)
Bracket
Quantity
of 4
(11)
Quantity
of 4
Plastic Anchor
(12)
7mm x 8mm
Screw For Wall
Quantity
of 4
Plastic Chain
Quantity
of 2
(1 )

“Antebellum” TV/Media Stand
Assembly Instructions
Assembly Instructions:
Wood may scratch easily. Be careful
when assembling. Do not scratch.
Step 1. Unpack and lay parts on
clean, padded surface like
carpet or blanket. Check that
you have all parts indicated
on the front page.
Step 2. Put the Bottom Base(A) on the
soft working surface.
Step . Insert the Wood Dowels(1) into
predrilled holes in Side Panel(B,C)
and Middle Panel(D,E).
Step 4. Attach the Side Panels(B,C) and
Middle Panels(D,E) to the Bottom
Base(A) with Bolt(2), then fasten
them.
Step 1. Attac
h the Left Door(F) to the
Left Side Panel(B) and Right
Door(G) to the Right Side
Panel(C).
Step 2. Attach Wood Knob( ) to Doors
(F,G) with Bolt For Wood
Knob(4).
Figure
Figure 1
(1)
8mm x 0 mm
Wood Dowel
Quantity
of 8
(6)
.5mm x 15mm
Screw For Magnet
Quantity
of 4
(2)
1/4” x 1”
Bolt
Quantity
of 8
(5)
Magnet
Quantity
of 2
(4)
5/ 2” x 22mm
Bolt For Wood Knob
Quantity
of 2
( )
Wood Knob
Quantity
of 2
Figure 2
Step 1. Put the Top Panel (H) on the
soft working surface.
Step 2. Attach Magnet(5) to the Top
Panel(H) with Screw for Magnet(6).

“Antebellum” TV/Media Stand
Assembly Instructions
Step 1. Insert the Wood Dowels(1) into
predrilled holes in Side
Panels(B,C) and Middle
Panels(D,E).
Step 2. Attach the Top Panel(H) to the
Side Panels(B,C) and Middle
Panels(D,E) with Bolt(2),
then fasten them.
Figure 4
Figure 6
Step 1. Insert Back Panel (I) into
grooves of side panels(B,C),
Top Panel(H) and Bottom
Base(A) with Screw For Back (7)
and tighten.
(1)
(2)
1/4” x 1” Bolt
8mm x 0 mm
Wood Dowel
Quantity
of 8
Quantity
of 8
Step 1. Insert the metal Pin(8) into
desired hole locations of inner
Side Panels(B,C) and Middle
Panel(D,E).
Step 2. Put the Adjustable Shelf(J,K) on
the Metal Pins(8)in each section.
Figure 5
(8)
Metal Pin
Quantity
of 12
.5mm x 12mm
Screw For Back
(7)
Quantity
of 22

“Antebellum” TV/Media Stand
Assembly Instructions
Figure 8
Figure 7
Step 1. Move this item
closed
to the
fastened wall Bracket(9) and tie in
both Bracket(9) with Plastic
Chain(1 ) as shown in diagram.
Step 1. Attach Bracket(9) to the
Top Panel(H) with Screw
For Bracket(10).
Step 2. Drill /16” pilot holes in near
proximity of the Bracket(9)
attached to the Top Panel(H)
and tap the Plastic Anchor(11)
into wall.
Step . Fasten Bracket(9) using
Screw For Wall(12) into the
Plastic Anchor(11).
(10)
(9)
Quantity
of 4
(11)
Plastic Anchor
Quantity
of 4
7mm x 8 mm
Screw For Wal l
Bracket
.5mm x 15 mm
Screw For Bracket
(12)
Quantity
of 4
(1 )
Plastic Chain
Quantity
of 2
Quantity
of 4

Customer Service 1
-
800
-
6
-
5096
[e-mail]
Southern Enterprises, Inc.
600 Freeport Parkway, Suite 200
Coppell, Texas, 75019
Customer Information
Name
Address
City/State/Zip Code
Phone Number
Please indicate where you purchased this item: Store/Website/Catalog
Please indicate color/size/style number:
Please immediately examine this product carefully. Any request for missing parts or damage replacement
must be received within 90 days of your receipt of the product. Replacement, if available, will be honored
within this time frame. Parts will not be available for items arriving fully assembled. We do not
recommend modifying product(s) and we are not responsible for any damages due to product
modification(s). If damages or missing parts are not reported within 90 days of your receipt, we are
under no obligation to provide parts or replacement merchandise.
Please contact Southern Enterprises at 800-6 -5096 or in Dallas 972-869-0111/ 9am 4pm Mon-Fri
Central time if you have product issues or email us at [e-mail]. Please ask for customer
service representative for issues involving damages or replacement parts. Please ask for technical
assistance representative for any issues with product and assembly/construction.
Please contact the retailer that you purchased from for returns.
Style No
Parts Letter
Parts Description
Quantity Needed
Parts Replacement Form

CAUTION
The top shelf is intended for a flat screen television with a maximum overall width
of 50” and supports up to 175 lb.
The top shelf is NOT INTENDED for tube televisions.
Each center shelf should not be loaded with more than 20 lb. Each side shelf should
not be loaded with more than 15 lb.
DO NOT EXCEED RECOMMENDED LOAD. Use with products heavier than the
maximum sizes and weights indicated may result in instability causing possible
injury.
This unit contains a permanent warning sticker located on under side of top shelf
or inside drawer.
Do not allow children under 16 years to move the cart.
Model: MS990600TX & MS991600TX & MS992600TX
“Antebellum” TV/Media Stand
Southern Enterprises, Inc
600 Freeport Parkway,
Suite 200 Coppell, Texas, 75019
Manufacture Date: 12/25/201