Spectrum Industries 55283 User manual

Important
Before using this product:
• Read this manual
• Comply with all safety and operating instructions
• Ensure all parts and correct quantities are included
Any parts damaged during shipment must be reported
within 5 days of receipt. To report information regarding
missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
Thank you for purchasing Spectrum products!
Spectrum product page:
http://bit.ly/LINK-OCC
Spectrum Industries, Inc
925 First Avenue, Chippewa Falls, WI 54729 USA
800 235 1262
715 723 6750
www.spectrumfurniture.com
Owner’s Manual
0116143R3 Page 1 of 8
LINK Lectern with Overbridge Control Console™
55283 36”H LINK Lectern with overbridge
55284 42”H LINK Lectern with overbridge

Important Safety and Care Instructions
0116143R3 Page 2 of 8
• Read this owner’s manual before assembly or operation.
• Do not allow children to move the lectern.
• Proceed slowly and carefully when moving the lectern.
• For indoor use only. Do not install or store the lectern where it will be exposed
to moisture.
• Do not block the ventilation openings.
• Avoid uneven loading of the equipment into the lectern. Uneven weight
distribution could cause the lectern to tip when the lectern is moving.
• Do not allow anyone to sit, stand, or climb on the lectern.
• Use a damp, soft-cloth, or sponge, with mild soap or detergent solution to clean
dirty surfaces. Do not use harsh solvents or abrasives.
• This lectern is intended for institutional use. It does not have any user-
serviceable parts or user-maintenance requirements. If servicing is necessary,
please contact Spectrum Industries for assistance.
Electrical Safety:
• Do not plug the power cord into an extension cord.
• Inspect power cords for damage before each use. Do not use power cords
that are damaged.
• Unplug power cord from electrical outlet by gripping the cord. Do not unplug
the power cord by pulling only on the cord.
• Do not step on, drive over, drag, or place objects on the power cord.
• For added safety, plug the lectern into a grounded outlet controlled by a GFI
(Ground Fault Interrupter) circuit breaker.
• Electrical devices are not toys. Children are often unaware of the hazards
associated with electrical devices. This lectern must always be used by
adults or with adult supervision.
Warning - Relocating audio and/or video equipment to furniture not speci cally
designed to support audio and/or video equipment may result in death or
serious injury due to the furnishing collapsing or over turning onto a child.
Warning - Death or serious injury may occur when children climb on audio
and/or video equipment furniture. A remote control or toys placed on the
furnishing may encourage a child to climb on the furnishing and as a result the
furnishing may tip over on to the child.

Assembly / Setup
0116143R3 Page 3 of 8
Overbridge insert panel
Figure 1
Note: The insert panel shown (shaded) is not included with the lectern or over-
bridge. This option needs to be ordered separately to complete the overbridge.
1/4-20 x 35mm
JC bolt
overbridge
insert panel
Tools Required
1/4-20 x 35mm
JC bolt
1. Identify all location(s) and sizes for controller(s) or electronics while making sure
all devices t within the maximum cutout space available in the overbridge panel.
See Figure 2-3.
2. Locate and mark the exact cutout area(s) on the panel. Note: Using masking
tape on cut lines will minimize laminate chipping while cutting.
3. Carefully make the cutout(s) in the overbridge panel using a jigsaw or router.
4mm Hex
wrench
Jigsaw or RouterDrill
Pencil Masking
tape
Drill bit
Measuring
device
1. To remove the overbridge insert panel, remove the (2) 1/4-20 x 35mm JC bolts with a
4mm hex wrench and lift out the panel. Figure 1.
2. To make cutouts in the insert panel [optional]:
3. Install controller(s) / electronics into panel.
4. Re-install the overbridge panel and secure with (2) 1/4-20 x 35mm JC bolts.

0116143R3 Page 4 of 8
2” grommet
LINK Lectern overbridge panel blank
(at view)
Overbridge section view
2” grommet
max cutout area
Figure 2
Figure 3
Note: The Overbridge Control Console™
has been designed for many of the cur-
rently available controllers on the market,
however, modied cutouts should be re-
viewed by Spectrum to ensure clearance
of brackets, keyboard slides, or other
objects under the worksurface.
Contact Spectrum to specify cutout size(s)
and location(s).

0116143R3 Page 5 of 8
4mm Hex
wrench
Tools
Required
Floor Anchoring (Toe Kick models only)
Figure 4
1/4-20 x 40mm JC bolt
(access from inside lectern)
4 req’d
Note: 4 fasteners are required
to anchor the toe kick to oor.
(fasteners not included).
LINK Lectern
access panel
toe kick
1/2” mounting holes
for oor anchors
1. If your LINK is equipped with a toe kick, and you wish to attach it to the oor, the toe kick
will need to be detached from the lectern. To detach, remove the (4) 1/4-20 x 40mm JC
bolts (one on each corner from inside the lectern) with a 4mm hex wrench.
2. Carefully lift the lectern off the toe kick. This will require several people. Figure 4.
3. Locate the toe-kick into its nal position on the oor and mark the (4) mounting hole
locations on the oor (The toe kick mounting holes are 1/2” dia.)
4. Drill holes into your oor and anchor the toe kick with appropriate fasteners.
5. Carefully lift the lectern back onto the anchored toe kick and align the (4) mounting holes.
6. Re-attach the lectern to the toe kick with the (4) previously removed JC bolts.
7. The access panel can be removed to access wiring below lectern.

0116143R3 Page 6 of 8
Wheel operation
Figure 8
Brake lever
1. To lock the wheel rotation, press the brake lever. Figure 8.
2. To resume operation, lift up on brake lever.
Moving and parking the lectern
• Before moving, unplug and secure all power cords.
• Close and lock doors.
• Remove any items from the top of the worksurface.
• Unlock the wheels.
• Push slowly and carefully. Do not move over uneven or irregular surfaces.
• Do not allow children to move.
• Lock the wheels after moving.
• Do not park unit in areas of heavy trafc.
• Do not run power cords across hallways, classrooms, or other areas where they will be walked on.
• Do not leave unit unattended in areas where children have access.
• Keep doors closed and locked whenever unit is unattended or parked.
• Keep wheels locked whenever the lectern is unattended.

0116143R3 Page 7 of 8
Accessories
Flip-up Shelf - 55140
22.75”W x 26.25”D
(mounts on left or right side)
includes 2” grommet, adjustable-height
(50 lbs max capacity)
Steel Handle - 55132
27.5”W
Note: Flip-up document shelf and steel handle are
interchangeable and can be mounted on either side.
LINK Lectern Rear Rack Rail Kit
55139 - 42” 19RU (15RU full-depth)
55134 - 36” 15RU (12RU full-depth)
Note: Power and communication wiring for docu-
ment cameras, laptop computers, and/or projec-
tors placed on the ip-up shelf should be routed
on top of the audience-side of the shelf. Use of
the shelf grommet hole for wiring will result in
pinching of the cords when the shelf is folded.
Overbridge Insert Panel
96504 - blank panel
96504mod - panel with cutout(s)
for overbridge version only-contact Spectrum to specify
cutout size(s) and position(s)-overbridge not available
separately (includes two 2” grommets with covers)
Universal Cord Reel Kit - 99037
• Includes universal mounting bracket
• Mounts horizontally or vertically
inside lectern to base panel
• 15’ [457.2 cm] retractable cord
• 12 AWG with breaker
• 10 lbs [.45 kg]
Note: When installed, the cord
reel takes up rack units from
the bottom of the rack rail.
Horizontal installation: 3RU
Vertical installation: 6RU
The cord reel is intended to provide temporary access to electrical outlets for
Spectrum mobile lecterns. Check local electrical codes prior to installation.
See spectrumfurniture.com for the latest
accessories and detailed warranty information.

0116143R3 Page 8 of 8
WE WILL MAKE IT RIGHT FOR YOU!
Spectrum is committed to provide complete customer satisfaction. Each of our products is manufactured from the best materials available and each
product is stringently monitored throughout the production process through our P.A.C.E. program (Product Assurance to meet Customer Expectations).
We expressly warrant that Spectrum products will be of good quality and workmanship and free from defect for the period set out in the warranty table below
from the date of delivery. This warranty shall not apply to defects or damage resulting from misuse, abuse, neglect, improper care, modifi cation or repair not
authorized by Spectrum, or any other cause outside the control of Spectrum. Spectrum will, at its sole option, either repair or replace the defective product.
This warranty is exclusive; no other warranty, written or oral, is expressed or implied. This warranty is given by Spectrum to Buyer and to no other per-
son or legal entity. No Spectrum dealer, distributor, agent or employee is authorized to make any modifi cation or addition to this warranty.
NOTWITHSTANDING ANYTHING TO THE CONTRARY, SPECTRUM WILL NOT UNDER ANY CIRCUMSTANCES BE LIABLE FOR INDIRECT OR LIQUI-
DATED DAMAGES, INCLUDING CONSEQUENTIAL, INCIDENTAL AND SPECIAL DAMAGES. IN NO EVENT SHALL SPECTRUM’S LIABILITY, WHETHER
UNDER CONTRACT OR WARRANTY, IN TORT OR OTHERWISE, EXCEED THE PURCHASE PRICE RECEIVED BY SPECTRUM FOR THE PRODUCT AT
ISSUE AND “RECALL ACTION” EXPENSES. SPECTRUM SHALL NOT BE SUBJECT TO ANY OTHER OBLIGATIONS OR LIABILITIES, WHETHER ARIS-
ING OUT OF BREACH OF CONTRACT, WARRANTY, TORT (INCLUDING NEGLIGENCE AND STRICT LIABILITY) OR OTHER THEORIES OF LAW, WITH
RESPECT TO PRODUCTS SOLD OR SERVICES RENDERED BY SPECTRUM, OR ANY UNDERTAKINGS, ACTS OR OMISSIONS RELATING THERETO.
Our Customer Service Department is ready to provide immediate attention to any questions, comments or concerns. They are available to answer your calls
Monday through Friday from 7 am to 5 pm CST. In addition your product comments or concerns are welcome via e-mail at: [email protected].
Item Warranty Period
effective 1/1/2015
Adjustable Crank / Electric Desk Legs • 1 Year
Flat Panel Desk Gas Cylinders
Chairs
• Adjustable Height Chair Parts – including frames, gas
cylinders, wood and plastic parts, control handles, casters
• Adjustable Height Chair Upholstery
• In-Stock Upholstery
• Graded-In Fabrics and Customer Owned Material
• 7 Years
• 2 Years
• 2 Years
• No Warranty
Height Adjustable Columns and Lifts • 1 Year
General Use Casters
Electrical (including timers and LINAK actuators) • 2 Years
Keyboard / Mouse Trays • 1 Year
Flat Panel Monitor Arms
• Flat Panel Monitor Arm – General Parts
• Flat Panel Monitor Arm – Gas Cylinders
• 5 Years
• 2 Years
Desks and Lecterns
• Computer Desk Chassis
• Cart Chassis
• Lectern Chassis
• 10 Years
Warranty Table
Warranty
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2015 Spectrum Industries Inc., All rights reserved.
8
DESIGNED AND MANUFACTURED IN
CHIPPEWA FALLS
WISCONSIN.USA