Spectrum Industries 95039 User manual

Assembly Instructions
0193134 Page 1 of 4
Assembly Instructions
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Undermount AV Channel
95039 - 36”W Pivot Premier
95038 - 48”W Pivot Premier
95037 - 60”W Pivot Premier
(4) 059984
2” Grommet (8) 0190174
#8 x 3/8” PHSM
Parts Bag
Assembly tip: Do not tighten component fasteners completely
until all have been installed. Keeping them loose will help with
alignment between parts during assembly.
(4) 0101382
#14 x 7/8” PHSM
Note: The Undermount AV Channel is not compatible
with an installed 95036 Undermount Rack Cabinet.
(1) 0169299
Center panel for
36” Pivot Premier
(1) 0169278
Center panel for
48” Pivot Premier
(2) 0169161
End panel
(1) 0168023
Center panel for
60” Pivot Premier
(1) of the following center panels will be included

0193134 Page 2 of 4
Attach end panels to center panel
1
Install 2” grommets
2
X4
(4) #8 x 3/8” PHSM
End panel
Center panel
2” Grommet
End panel
Note: Assembly steps shown are the same for all three AV channel sizes

0193134 Page 3 of 4
Remove modesty panel from Pivot Premier
3
Attach AV channel to worksurface
4
Modesty panel
X 2
+
-
#14 x 7/8” PHSM
(4 total)
AV channel
assembly
Assembly tip: There are two sets of pilot holes available
for the AV channel under the Pivot Premier worksurface.
(Left and right positions).

0193134 Page 4 of 4 © 2022 Spectrum Industries Inc., All rights reserved.
1500 RIVER STREET, PO BOX 400, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
Re-install modesty panel
6
Modesty panel
X 2
+
-
Install electronic equipment
5
Undermount AV
channel assembly
Note: Mounting slots in the undermount AV channel are
designed to provide multiple mounting options for AV over IP
decoders or other light AV electronics.
Tabs go into
worksurface
slots rst