Spectrum Industries 96501 User manual

0113405 Page 1 of 2
Assembly Instructions
Before you begin, please make sure all parts and proper quanti-
ties are included. Any parts damaged during shipment must be
reported within 15 days of receipt. To report information regarding
damages or if you have any questions, please call 1-800-235-1262.
To purchase parts or accessories, please contact us at
www.spectrumfurniture.com
1-800-235-1262
Thank you for purchasing Spectrum products!
Blank Overbridge Panel
#96501 - small
#96504 - medium
#96507 - large
(2) 039622
2” round grommet
1. Layout cutout(s)
Note: The overbridge panel is
symmetrical. Rotating the panel 180°
and re-attaching to the overbridge will
place the cutout on the opposite side
of the overbridge if necessary.
A. Before any cuts are made, determine the size of the cutout(s) needed on the overbridge panel.
B. The panel dimensions and recommended maximum cutout sizes are shown in Figure 1. Determine which panel you
have (small, medium, or large) and the preferred location on the panel for your controller (left, centered, or right).
Small panel
Figure 1
Tools Required
Drill Jigsaw
(2) 0102063
1/4-20 x 35mm JC bolt
(1) 025039
4mm Hex Wrench
Tape measure
Pencil
Router
(optional)
4mm Hex wrench
(included)
Suggested tools
to make cutouts
Medium panel
Large panel
max cutout area
max cutout area
max cutout area

2” grommet
0113405 Page 2 of 2
925 First Avenue, PO Box 400, Chippewa Falls, WI 54729 Ph: 1-800-235-1262 Fax: [phone]
E-mail: [email protected] web: www.spectrumfurniture.com
Figure 2
3. Attach panel to overbridge frame
A. Set the panel into the overbridge frame opening. Note: It may be
easier in some cases to install the controller in the panel before
attaching the panel to the overbridge.
B. Secure with (2) 1/4-20 x 35mm JC bolts and tighten securely.
C. Install (2) 2” grommets.
C. Determine the depth of your controller and verify it will not collide with the worksurface or
any other objects under the overbridge when the panel is attached. Figure 2.
D. When the cutout location(s) have been vered, mark each cutout on the panel with a pencil.
1/4-20 x 35mm
JC bolt (2 req’d)
overbridge panel
overbridge
frame
Figure 3
overbridge
panel
2. Make panel cutouts
A. Make the cutout(s) in the panel with a jigsaw or router.
Note: Masking tape can be used on the laminate-side at
the cut lines to minimize chip-out.
overbridge
section view