Steelcase kick Worksurface User manual

Page 1 of 6
939504841 Rev D
kick™Worksurfaces
page 4
page 4
page 5
page 6
If you have a problem, question, or request,
call your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2012 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
®

Page 2 of 6
939504841 Rev D
Cantilever and Tie Strap
See Cantilever
Assembly Instruction 939504645
11" Center H-Leg (standard)
See H-leg
Assembly Instruction 939504843
20" H-Leg (standard)
See H-leg
Assembly Instruction 939504843
Pedestal Filler
See pedestal filler
assembly instruction 939504842
Attaching Brackets (page 3)
Mounting Brackets (page 3)
Leg page 5
27 1/2"
Mounting Worksurfaces
1. Mark height of worksurfaces to 27 1/2". Attach
the support brackets to the vertical junctions. A
minimum of 1 pilot hole per corner and side
support bracket is provided. All other supports
contain a minimum of 2 pilot holes.
®

Page 3 of 6
939504841 Rev D
2. Lay worksurfaces on supports for the entire
workstation cluster loosely securing each surface
to supports and adjust worksurfaces for optimal
appearance. Secure screws starting with corner
workstation.
Attaching Adjoining Worksurfaces
Place support plates as shown. Secure a screw in
all available holes.
Primary
Wing
Wing
Primary
Primary
Wing
Primary
Wing
®

Page 4 of 6
939504841 Rev D
See page 2 for support information
®

Page 5 of 6
939504841 Rev D
See page 2 for support information Post Leg Orientation
®

Page 6 of 6
939504841 Rev D
See page 2 for support information
®