Steelcase Tour Cabinet User manual

© 2009 Steelcase Inc.
GrandRapids, MI 49501 U.S.A.
Printed in U.S.A.
HV Cabinet Shared Bookcase Personal Bookcase
HV cabinet mounted vertical:
or
#2 SQUARE
DRIVE
T27 TORX
DRIVE
11/32" DRILL BIT
1. HV cabinet and shared bookcase can be positioned
vertically or horizontally on Tour counter. They may be placed
at any locationalong the length of the counter and can face
any direction.
Tour®Cabinets and Bookcases
Two (2) stability fastenersmust be
installed indiagonal positions. Shared Bookcase Vertically on a 30" Tour Counter
When installing a Shared Bookcase vertically on a 30" Tour Counter with no
additional storage elements next to it. Install the included hardware kit
consisting of:
(1) 1/4-20 x 1-1/2" T27 Drive Bolt
(1) 1/4-20 Standard Washer
(1) 1/4-20 Standard Nut
through the outer-most oblong hole
using a 11/64" drill bit into and through
the bottom of the bookcase.
the head facing up.
bolt on the bottom side of the counter
and securely fasten.
Turn set screws in slightly to increase
doors sliding resistance if necessary.
®
Page 1 of 4
P/N 939500283 Rev E

2a
PILOT
HOLE
2b
BOTTOM OF
BOOKCASE
TOP OF
BOOKCASE
GANGING
BRACKET
2c 2d 2e 2f
SCREW
2. The personal bookcase may be positioned on the counter as shown below (2a). When
standing vertically, two(2) bookcases must be turned upside down and positioned
back-to-back (2b). To gang the two bookcases, locate each ganging bracket on the
then re-install the four (4) screws(2e). Flip bookcases over and lower onto counter (2f).
Optional Legs
3. The personal bookcase may be
set on the floor and connected to
the counter. First, flip unit
upside-down.
Position personal bookcase legs
as shown and attach each
personal bookcase legs using
three (3) screws.
PERSONAL
BOOKCASE
LEG AND
BRACKET (LH &
RH)
®
Page 2 of 4
P/N 939500283 Rev E

SCREW
a b
c
e
d
(Fig. 1)
STABILIZER
HOOK
BRACKET
4. Place cabinet underneath counter. Install stabilizer
bracket to each side of cabinet leg as shown (Fig. 1).
®
Page 3 of 4
P/N 939500283 Rev E

1"
1"
TAPE
5. Use countertops (ordered
separately) to fill in areas not
covered by cabinets.
NOTE: See specification guide for
application rules pertaining to units
placed on top of counter.
When countertop is adjacent to cabinet or bookshelf, apply 1 piece of double-sided
tape to hold countertop to counter. Tape is supplied with cabinet or bookshelf.
6. HV cabinet can only be
positioned horizontally on pile file.
®
Page 4 of 4
P/N 939500283 Rev E