Steelcase Tableau Firmware update

Assembly Directions
Tableau-Service Modules
Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Y9501890
Tools
Page1of6
Service modules
with doors
Service modules
without doors
REV C

1. Set the service module on top of a credenza which is the same width. Make sure the service
module sides and back edge are flush to the credenza.
Steelcase Y9501890
Page2of6

Assembly Directions
2. Secure service module with the angle brackets provided.
Steelcase
Page3of6 Y9501890
(2) screws
each bracket,
1” pan head

Steelcase
Page4of6
4a.
3.
Y9501890
The backside of the tackboard has velcro (
and two metal angles
which rest on top of the tackboard frame. Turn tackboard
around and insert onto the tackboard frame.
which enables
it to stick to the tackboard frame)
NOTE: Upper unit not shown for clarity.
VELCRO
BACK OF
TACK PANEL
must rest on
tackboard frame
BRACKETS
(2) screws
each end,
2” pan head
ONE FULL LENGTH TACK PANEL
Align through holes in tackboard frame
with predrilled holes in side panels,
then secure as shown.
NOTE: Upper unit not
shown for clarity.

Steelcase
Page5of6 Y9501890
4b. The backside of the slatwall has four (4) metal clips
which hang on clips mounted to the tackboard frame.
(Fig. 1). Turn tackboard over and insert onto the top of
the tackboard frame (Fig. 2). bracket.
NOTE: Upper unit not shown for clarity.
Fig. 1
Fig. 2
VELCRO
HANG CLIPS
HANG CLIPS
VELCRO
BACKSIDE
OF SLATWALL
must rest on
tackboard frame
BRACKETS
TWO PIECE TACK PANEL WITH SLATWALL

Steelcase
Page6of6 Y9501890
Adjust door hinges as needed.
Middle Screw-
In/Out
ARear Screw-
Up/Down
BFront Screw-
Side to Side
C
CA
B
DOOR
5.