Steelcase Curency Enhanced Towers Guide

Curency®Enhanced - Towers, Counterweights,
Glide Leveling and Shelf Adjustment
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2021 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
®
Page 1 of 4
Doc # 158170 Rev A
WARNING: TIP OVER HAZARD
DO NOT:
pull down on doors
12 " wide towers must be attached to a wall,
under worksurface storage or an end panel.
move unit while loaded
move unit by lifting from its top
DO NOT:
You MUST:
WARNING
TIP OVER
HAZARD
Install this unit against a wall or gang
to a similar unit.
FOLLOW THESE INSTRUCTIONS TO
PREVENT UNIT FROM TIPPING OVER AND
CAUSING INJURY.
See Assembly Directions for further
instruction, available from Steelcase
dealer or call 1-888-783-3522
Pull down on doors (if equipped)
Move unit or adjust glides if loaded

®
Page 2 of 4
Doc # 158170 Rev A
Leveling a Cabinet
without Drawers
1. Adjust leveling glides.
Leveling a Cabinet
with Drawers
1. Unlock (1a) and remove
bottom drawer (1b).
2. Adjust leveling glides.
To remove drawers
push lever down on one
side, and up on the other.
1a
1b
OR
2
1

®
Page 3 of 4
Doc # 158170 Rev A
UP/DOWN
IN/OUT
SIDE TO
SIDE
DOOR HINGE
Hinge Adjustment
Adjust doors. A #2 screwdriver is
recommended for adjusting hinge.
Adjustable Shelf Installation
1. Install (4) shelf pins per shelf in desired
location as shown.
2. Lower each shelf into place.
2
2
1
1

®
Page 4 of 4
Doc # 158170 Rev A
Install both counterweights
on top of each other, behind
the drawers, using four (4)
#10 x 2" flat head screws
through the holes provided.
For style # CRTW
(Single Door above Drawers)
Two (2) counterweights are required.