Steelcase Universal Storage User manual

Page 1 of 5
939504456 Rev D
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2003 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
Universal Storage - Installation of Coat Hook,
Front to Back Coat Rod and Side to Side Coat Rod
ACR2 BIT
Front to Back Coat RodCoat Hook Side to Side Coat Rod
Page Topic
2 Installing a Coat Hook
 3 Installing a Front to Back Coat
  Rod to the Top
 4 Installing a Front to Back Coat
  Rod Under a Shelf
 5 Installing a Side to Side Coat Rod
Table of Contents

Page 2 of 5
939504456 Rev D
Installing a Coat Hook
1. Open door of cabinet. Attach screw
and spacer into lower hole.
2. Slide coat hook over screw/spacer
(2a) and attach with screw through upper
hole (2b). SPACER
SCREW
COAT HOOK
2a1
SCREW
2b
Note: Doors in
drawing are
removed for clarity.

Page 3 of 5
939504456 Rev D
Installing a Front to
Back Coat Rod to
theTop
1. Install bracket in slot in
back.
2. Slide rod into the slot in
the rear bracket.
3. Insert rod into front
bracket. Attach front bracket
to top using two (2) screws.
NOTE: Front bracket uses the
same screws and holes as the
door stop.
2
1
COAT ROD
3
DOOR STOP
BRACKET
FRONT BRACKET
(PLACE FRONT BRACKET
OVER DOOR STOP
BRACKET AND ATTACH
BOTH WITHTHE
SAME 2 SCREWS)
BACKTOP
MOUNT
BRACKET

Page 4 of 5
939504456 Rev D
Installing a Front to
Back Coat Rod Under
a Shelf
1. Attach rear bracket to
underside of back of shelf using
one (1) screw.
2. Slide coat rod into the slot in
the rear bracket.
3. Using a tape measure, mark
the center of the shelf. Using
the mark as a guide, center the
front bracket and use the holes
in the bracket as guides for the
self-drilling screws. Make sure
the bracket is flush with the front
of the shelf. Use self-drillin
screws to attach the front
bracket.
BACKTOP
MOUNT
BRACKET
UNDERSIDE
OF SHELF
1
FRONTTOP
MOUNT
BRACKET
3
COAT ROD
2

Page 5 of 5
939504456 Rev D
Installing a Side to Side
Coat Rod
1. Attach the side mounting plate to
the side of the cabinet using two (2)
screws. Repeat for other side.
2. Place the end of the coat rod into
each side mounting plate.
Note: Doors in
drawing are
removed for clarity.
1
SIDETO SIDE
MOUNTING
PLATE
2
COAT ROD