Stryker Reprocessed Stanley Bed Alarm Sensor Pad User manual

SSS •1810 West Drake Drive, Tempe, AZ 85283 USA •www.sustainability.com •888-888-3433 SSS-HAS
K-120-F178 Effective Date: 5/28/2015
Reprocessed for
Instructions for Use
Reprocessed Stanley Bed Alarm Sensor Pad
Reprocessed Device for Single Use. Reprocessed for Stryker Sustainability Solutions.
Caution: Federal (U.S.A.) law restricts this device to sale by or on the order of a physician.
NON-STERILE NOT MADE WITH NATURAL RUBBER LATEX
Explanation of Icons
Date of Reprocessing
Use by Date
Product Code
Do Not Reuse
See Instructions For Use
Indications for Use
The Stryker Sustainability Solutions Reprocessed Stanley Bed Alarm Sensor Pads are designed to detect when the patient lifts off the
bed. These sensor pads must be connected to a compatible Stanley Bed-Check Alarm Unit.
Instructions for Use:
1. Place sensor pad on top of mattress, across the width of the bed. For best sensitivity, place the sensor pad above any pads
(exception: incontinence pad) or mattress covers. Only the bottom sheet (and incontinence pad, if used) should be between
the sensor pad and the patient.
a. Adjust sensor pad position to be under the patient’s buttocks (3”-5” below mattress bend)
b. As an alternative, especially for “faster” patients, the sensor pad may be placed under the shoulder blades.
2. Secure sensor pad in position: use the enclosed rubber bands and clips, attach clips to bedsprings, frame or mattress piping.
3. Connect sensor pad to the alarm unit.
4. For continued safety, test system performance before using and daily thereafter.
5. For troubleshooting, consult the User Guide.
6. Clean by wiping sensor pad with a non-caustic sanitizing solution.

Reprocessed Posey Bed Alarm Sensor Pad
SSS •1810 West Drake Drive, Tempe, AZ 85283 USA •www.sustainability.com •888-888-3433 SSS-HAS
K-120-F178 Effective Date: 5/28/2015
Warnings:
Do not roll or fold the sensor pad.
Always verify system is working properly before leaving the patient unattended.
Do not submerge the sensor pad in liquid or sterilize it with heat.
Do not remove labeling from sensor pad during the life of the product.
Figure 1 - Sensor pad locations
The OEM information listed on the label is provided as device ID prior to reprocessing and may contain the trademarks
of unrelated third parties that do not sponsor this device.
This product and its packaging have been exposed to ethylene oxide gas (EtO). Even though the product is processed
in compliance with all applicable laws and regulations relating to EtO exposure, proposition 65, a State of California
voter initiative, requires the following notice:
Warning: this product and its packaging have been exposed to ethylene oxide. The packaging may expose you to
ethylene oxide, a chemical known to the State of California to cause cancer or birth defects or other reproductive
harm.