Sunny Health & Fitness SF-E3607 User manual

STEP 3:
*Important: Please read entire page before starting this step and note all cautions.
Attach the Shaft (No. 27) into the Handlebar Post (No. 2), then insert a Wave
Washer (No. 54) and attach the Left Swing Tube (No. 6L) to the left side of Shaft
(No. 27). Next, fix the other end using Flat Washer (No. 25),Spring Washer (No. 52)
andHex Bolt (No. 24). NOTE: Do not tighten the bolts all the way yet.
CAUTION! Part 38 is labeled L for LEFT and R for RIGHT. Do not try to install
the Left Bolt on the Right Crank and vice versa. The Left Bolt is only meant for
the Left Crank; the Right Bolt is only meant for the Right Crank. Make sure to
turn 38L counterclockwise to tighten and 38R clockwise to tighten.
The Left Nylon Nut (No. 42L) is black. The Right Nylon Nut (No. 42R) is silver.
Keep the Right and Left Hinge bolt (No. 38R/L) at a 90° angle to the Crank (No.
22). The Right and Left Hinge Bolt (No. 38R/L) must be perfectly straight as it
goes through the Pedal Support to the Crank. If Hinge Bolt (No. 38R/L) is
connected to Crank at an angle, permanent damage to both the bolt and the
Crank may occur.
Insert the Left Hinge Bolt (No. 38L) through the Left Pedal Support (No. 5L). Put
Wave Washer (No. 45),Spring Washer (No. 41) and Nylon Nut (No. 42L) on the
end of Left Hinge Bolt (No. 38L). Insert Left Hinge Bolt (No. 38L) into the Left
Crank (No. 22). NOTE: Do not tighten the bolts all the way yet.
Attach the Left Swing Tube (No. 6L)to the Left Pedal Support (No. 5L) with Hex
Bolt (No. 30),Flat Washer (No. 31) and Nylon Nut (No. 32).
Now, tighten Hex Bolt (No. 24),Hex Bolt (No. 30) and Nylon Nut (No. 42L) and
cover the bolts with Caps (No. 23, 57, 43, & 36).
Repeat the above steps to assemble to right side.
Attach the Pedals (10L/R) to the corresponding Pedal Supports (No. 5L/R) using
Hex Bolts (No. 33),Flat Washer (No. 34) and Nylon Nuts (No. 35).
Tighten all the Inner Hex Bolts (No. 16), on the Handlebar Post (No. 2).