Sunricher SR-2830A User manual

RF Single Color Wall Mounted Controller 09.2830A.04183
Brightness slider, touch to choose brightness
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Click to turn on/off
Press and hold down to save
color; Click to recall the saved
Total 4 zones, click to choose zone,
Press and hold down to turn on/off
corresponding zone
Back side
60.3 mm
RF Wall
Panel Controller
DC Power input
V- V+
52.0 mm
60.3 mm 52.0 mm
19.4 mm
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
Wiring diagram
Output Signal RF signal
Power Supply 12-24VDC
Power consumption 20 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 86x86x29.1mm
• Touch sensitive
• Glass interface(white & black)
• Compatible with all universal series RF receivers, radio frequency: 869.5/434MHz
• Control single color
• Control 4 zone of RF receiver synchronously and separately
• Waterproof grade: IP20
RF Wall
Panel Controller
V- V+
12-24VDC
PSU
AC 100-240V
DC Version
RF Wall
Panel Controller
AC Version
NL
AC Power input
RF signal
100-240VAC
20 mA
0-40°C
8% to 80%
86x86x29.1mm
DC Version AC Version
DC Version
AC 100-240V
AC Version
RF Wall
Panel Controller
AC Version
NL
AC Power
50/60Hz
AC Power
50/60Hz

Installation
12-24VDC
Power Supply
DC version needs connect
with DC power supply
Pair with RF receiver
Step 2:Choose and click a zone number(e.g. zone 4)
Step 1:Click the “Learning Key” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 3:Touch the brightness slider, LED lights connected with the RF receiver
flicker once means the receiver is paired with zone 4 successfully.
Save color/scene/mode
Step 1:Choose and click one or multiple paired zone numbers(e.g. zone 1)
Step 2:Touch the brightness slider to select the scene you like
Step 3:Press and hold any scene buttons of S1-S3(e.g. S2) , LED lights
connected with the RF receiver flicker once means the color/scene was
saved successfully.
Recall the saved colors/scenes
Step 2:Click any scene buttons of S1-S3(e.g. S2) to recall the saved scene
Step 1:Choose and click one or multiple paired zone numbers(e.g. zone 1)
1. Do wiring the wall panel & RF receiver according to wiring diagram (please refer to the instruction of RF receiver that
you would like to pair with)
2. Power on, then touch the button to turn on the controller, indicator of the controller turned blue
Operation