Sunricher SR-2833t1 User manual

RF Single Color Wall Mounted Controller 09.283T1.04211
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Zone 1 Zone 2
Click to turn on,
press and hold down
to increase light intensity
Click to turn off,
press and hold down to
decrease light intensity
Back side
60.3 mm
RF Wall
Panel Controller
DC Power input
V- V+
52.0 mm
60.3 mm 52.0 mm
19.4 mm
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
Wiring diagram
Output Signal RF signal
Power Supply 12-24VDC
Power consumption 200 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 86x86x29.1mm
• Touch sensitive
• Glass interface(white & black)
• Compatible with all universal series RF receivers, radio frequency: 868/869.5/434MHz
• Control single color
• Control 2 zones of RF receiver synchronously and separately
• Back lighting for finding in the dark
• Waterproof grade: Ip20
RF Wall
Panel Controller
V- V+ D+ GNDD-
DMX O UTPUT
12-24VDC
PSU
AC 100-240V
DC Version
RF Wall
Panel Controller
AC Version
NL
AC Power input
RF signal
100-240VAC
15 mA
0-40°C
8% to 80%
86x86x29.1mm
DC Version AC Version
DC Version
AC 100-240V
AC Version
RF Wall
Panel Controller
AC Version
NL
AC Power
50/60Hz
AC Power
50/60Hz

Installation
12-24VDC
Power Supply
DC version needs connect
with DC power supply
Pair with RF receiver
Step 2:Click the “Learning Key” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 1:Do wiring the wall panel & RF receiver according to wiring diagram
(please refer to the instruction of RF receiver that you would like to pair with)
Step 3:Choose one zone and touch or button of the zone(e.g. zone 2),
LED lights connected with the RF receiver flicker once means the receiver is
paired with zone 2 successfully.