Sunricher SR-2830RGB User manual

RF RGB Wall Mounted Controller 09.283RI.04193
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Press and hold down to
save color; Click to recall
the saved
Press and hold down to
increase/decrease light
intensity
Total 4 zones, click to
choose zone, Press and
hold down to turn on/off
corresponding zone
Color slider, touch to select R/G/B color
Click to play / pause the
10 built-in effects, Press
and hold down to speed
up/down the running effect
Click to turn on/off
19.50 mm 71.00 mm
53.00 mm
Output Signal RF signal
Power Supply 12-24VDC
Power consumption 20 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 120x80x29.1mm
RF Single Color
Wall Mounted Controller
Back side
83.00 mm
101.00 mm
• Touch sensitive
• Glass interface(white & black)
• Control RGB color
• Control 4 zones synchronously and separately
• Compatible with all universal series RF receivers, radio frequency: 869.5/434MHz
• Waterproof grade: Ip20
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
Wiring diagram
DC Power input
12-24VDC
PSU
AC 100-240V
DC INPUT
V+ V+ V- V-
L L NN
AC INPUT
DC Version
AC Version
AC Power input
RF signal
100-240VAC
20 mA
0-40°C
8% to 80%
120x80x29.1mm
DC Version AC Version
RF Single Color
Wall Mounted Controller
DC IN PUT
V+ V+ V- V-
RF Single Color
Wall Mounted Controller
L L NN
AC IN PUT
DC Version AC Version
AC 100-240V
AC Power
50/60Hz
AC Power
50/60Hz

Installation
Pair with RF receiver
Step 2:Choose and click a zone number(e.g. zone 4)
Step 1:Click the “Learning Key” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 3:Touch the slider, LED lights connected with the RF receiver
flicker once means the receiver is paired with zone 4 successfully.
Built-in 10 color changing modes are as follows:
Mode 1: Any two colors of RGB mix fade-in & fade-out
Mode 2: RGB three colors mix fade-in & fade-out
Mode 3: RGB three colors mix fade-out & fade-in
Mode 4: RGB flash
Mode 5: RGB three colors fade-in & fade-out successively
Mode 6: RGB three colors fade-in successively
Mode 7: RGB three colors fade-out successively
Mode 8: RGB three colors jump changing successively
Mode 9: R&B two colors mix fade (R in B out), then G fade-in, then R&B mix fade (R out B in), then G fade-out
Mode 10: B fade-out, then G&B mix fade (G out B in), then R&G mix fade (R out G in), then R fade-in
Click the paired zone number/numbers, then touch the slider or the other buttons to do the controlling
Operate the remote after pairing
1. Do wiring the wall panel & RF receiver according to wiring diagram (please refer to the instruction of RF receiver that
you would like to pair with)
2. Power on, then touch the button to turn on the controller, indicator of the controller turned blue
Operation
①
②