Supertrax Audi Q3 Owner's manual

Audi Q3 Style Kids Ride on Car
Installation and Operation Instructions
Please read this instruction manual carefully. It is
important to read and follow all of the steps during
assembly to ensure proper operation and safety of the
child. Please keep this manual for future reference.

SPECIFICATIONS:
Car Type:
Audi Q3 Style
Battery Type:
12V7AH
Electric Motor:
12V30W(Drive) 12V8W(Steering)
Age Range:
2 –5 Years
Max. Weight:
65 lbs
Product Size:
50”L x 34”W x 25”H
Avg. Speed:
2 –3 MPH
Charging time:
8-12 hrs
Avg. Use Time:
1-2 Hrs (depending on use)
Remote Battery:
2 - AA (not included)
IMPORTANT!
•Assembly of car and charging of
battery is only to be done by an
adult.
•WARNING!! NOT TO BE USED
ON STREETS or IN TRAFFIC.
•Never modify the electric
circuit system or tamper with
electric system. Can cause
permanent damage.
•Please check the product
regularly for any loose parts or
wires to ensure proper
operation.
•Adult supervision is
recommended during
operation by child to avoid
injury. Safety equipment is
recommended.
•Please make sure that the child
uses caution to avoid falls and
collisions causing injury to the
child or third party.
•Do not pick up vehicle by
steering wheel.
•Do not pick up battery by wires
or charger.
•Keep all plastic bags out of the
reach of young children.
•Not recommended for children
under the age of 2 yrs. due to
small parts that could cause a
choking hazard.
•Battery must be charged for a
minimum of 8-12 hours prior to
first use of the car to avoid
damage to the battery. Car
power switch must be in off
position when charging.
•Battery charger should be
examined for damage prior to
each use. It is important to
inspect the cord and both ends
for damage. In the event, there
is damage found, DO NOT USE
THE CHARGER! Contact us for
replacement charger.
•Please retain instruction
manual for future reference.
•Please retain packaging in the
event it is necessary to return
for repair.

If the charger is plugged into the charging port, the car will not
power up regardless if the charger is plugged into the wall outlet
or not.
PARTS LIST:
1
Car Body
7
Windshield
13
Remote Control
2
Front Wheels
8
Seat
14
Charger
3
Wheel Covers
9
Left Window
15
Screws & Nuts
4
Rear Wheel
10
Right Window
16
Cotter Pins
5
Drive Motor
11
Back Window
6
Rearview Mirror
12
Steering Wheel
ASSEMBLY INSTRUCTIONS:
1. Install the car windows, rear windows, and rear speaker deck: Snap rear
speaker deck into place at the rear of the car. Snap rear window into place
and secure with screws from the bottom of the car. Snap door window into
place on the upper part of the door and secure with 5 screws. Repeat steps
for both door windows.

2. Installing the seat and exterior rearview mirrors: Before putting seat into
place, need to make electrical connection at the battery. Make sure that the
black wire is connected to the negative pole on the battery and the red wire is
connected to the positive pole on the battery. (red to red & black to black)
Set seat into place over the battery area. Slip tabs on the back of the seat into
slots in the body. Press the front/center of the seat down and toward the
back of the car until it snaps into place. Install the exterior rearview mirrors
into place and secure with screws from the bottom of the car.
3. Install front wheels: Install a washer on the front axle. Install a bushing to each
side of wheel. Slide wheel onto the axle, making sure to keep bushings installed
in the wheel stay in place. Install washer and insert cotter pin through the hole in
the axle and spread ends of cotter pin to make sure that it cannot slip out of the
axle. Install wheel covers onto the wheels. There are 2 tabs on the wheel covers
that need to be lined up with slots in the wheels. Secure wheel covers with 3
screws. Repeat steps for second wheel. See Fig 1

4. Install the rear wheels and motor/gearbox: Disconnect the electrical connection
from motor/gearbox located near the battery on the left side of the car. Slide
motor/gearbox onto the rear axle while feeding the electrical connection through
the hole in the body into the battery area and reconnect the electrical connection
previously disconnected. Install a bushing to each side of wheel. Slide wheel
onto the axle, making sure to keep bushings installed in the wheel stay in place.
Install washer and insert cotter pin through the hole in the axle and spread ends
of cotter pin to make sure that it cannot slip out of the axle. Install wheel covers
onto the wheels. There are 2 tabs on the wheel covers that need to be lined up
with slots in the wheels. Secure wheel covers with 3 screws. Repeat steps for
second wheel. See Fig 2
5. Install Gauges and Windshield: Match color of electrical connector on gauges
to corresponding electrical connector on the dash and make connection. Snap
gauge into place on the dash. Repeat steps for 2nd gauge. Insert the
windshield to proper location on the front of the dash area. Snap into place
and secure with 2 screws.

6. Install Steering Wheel: Connect electrical connection between the steering
wheel and the wires from the car. Slide steering wheel onto the steering
shaft. Align the screw hole in the steering shaft and the steering wheel and
slide the bolt through the hole. Apply the nut to the end of the bolt and
tighten until snug.
Charging the battery: The charging port is located just under the front portion of the
seat. Plug the charger into the charging port first, then plug the charger into wall
outlet. BATTERY MUST BE CHARGED FOR A MINIMUM OF 12 HOURS BEFORE
INITIAL USE TO AVOID DAMAGE TO THE BATTERY.
REMOTE CONTROL BATTERY INSTALLATION: Open battery cover on the back of the
remote control. Install 2 AA Batteries as indicated inside the cover. Replace battery
cover and secure with screw.

Once battery is fully charged, disconnect from charger. Depress power button to turn on
the car. Once power is on, all lights light up, accompanied by the sound of the engine. (If
no sound is heard, turn up the volume) To allow child to operate the car, remote
control/manual switch has to be set to the manual position. To move the car forward,
forward/reverse switch has to be set to the forward position and to move the car
backward, the switch will need to be set to the reverse position. To operate the car using
the remote control, remote control/manual switch has to be set to the remote control
position.
The buttons found on the handlebars are for the horn and the on board music. There is a
MP3 interface located on the dash area with a volume knob to control the level of sound.

TROUBLE SHOOTING GUIDE:
Problem
Possible Cause
Possible Solutions
Car will not move
1. Battery voltage is low.
2. Screw on the wheels may
have come loose.
3. Battery connector may
have come apart or have
a bad connection.
4. Battery is damaged
5. Electrical box is damaged
6. Motor is damaged
Charge the battery
Re-tighten screws on
wheels.
Re-connect the battery
connector to the car
electrical connector
Replace battery
Replace motor
The battery will not
charge.
1. Battery connector may
have come apart or have
a bad connection.
2. Battery charger plugged
into a bad wall outlet.
3. Battery charger is
damaged.
Re-connect the battery
connector to the car
electrical connector
Try another wall outlet
Replace battery charger
Shortened battery life
Battery was not charged fully
Battery is old
Charge battery fully
Change battery
Some Noise and heat
when charging
battery
Chemical reaction
Normal
Low Speed
Battery is old
Battery is low on charge
Weight limit exceeded
Uneven or uphill path
Change the battery
Charge the battery
Do not exceed max
weight limit
Noise coming from
motor/gearbox
Gear in motor/gearbox broken
Call for replacement
motor
The car shakes when
moving
Bad Connection of the motor
wires
Possible motor failure
Reconnect wires
Call for replacement
motor
If you are unable to solve a problem, please feel free to contact us.

IMPORTANT REMINDERS:
•Prior to first use of this electrical vehicle, please charge the battery for a
minimum of 12 hours. Failure to complete this step will cause permanent
damage to the battery.
•Do not operate on streets, roads, steep slopes, through ditches or in any
dangerous areas.
•Do not operate on slick surfaces, such as; marble, floor tile, ice.
•This product is limited to one rider. DO NOT OVERLOAD. Max weight 65
pounds!
•Do not switch forward to reverse while vehicle is in motion.
•Keep car, remote control, and charger away from water and/or rain to avoid
circuit damage
•Do not continue operation when car is stopped by an obstacle. Move car
away from obstacle prior to resuming operation.
•Do not use in or near water.
•Any liquid in the car may cause damage.
•Not for indoor use, may cause damage to furniture, walls, and other third
party.
•When remote control batteries are discharged, the car will become sluggish
and jitter, replace batteries.
•When not in use, please turn off power switch. If not using for an extended
period of time, please disconnect the battery.
CHARGING and BATTERY MAINTENANCE:
•IMPORTANT! Battery must be charged for a minimum of 12 hours prior to first
use of the car to avoid damage to the battery.
•When connecting the charger, please install the plug into the car prior to
plugging charger into the wall socket.
•Charging time for battery is 8-12 hours
•DO NOT EXCEED 20 hours when charging.
•Only use the battery supplied with this car to avoid damage to the car.
•Adult supervision is advised for connecting charger.
•Never reverse polarity of the battery + to red and –to black.
•Never short circuit battery! Do not touch red wires to black wires.
•For remote control: it is not recommended to use rechargeable batteries.
WARNING:
Please keep small parts away from children to avoid choking.
GENERAL MAINTENANCE:
1. It is important to recheck all parts and components that were installed
periodically to ensure proper operation.
2. For cleaning, simply wipe off with damp cloth.
3. Visual inspection and appropriate maintenance is necessary to
maintain the safety of your child.
4. Maintain the safety of your child.