Supertrax WideTrack Parts list manual

WideTrack
Kids Ride on Car
Assembly and Operation Instructions
Please read this instruction manual carefully. It is important to
read and follow all the steps during assembly to ensure proper
operation and safety of the child. Please keep this manual for
future reference.
Scan this QR Code
to view the
Assembly Video

SPECIFICATIONS:
Battery Type:
2 - 12V7AH
Avg. Speed:
Approx. : 2 –5 MPH
Age Range:
2 –7 Years
Charging time:
8-12 hrs –Minimum
1 Charge per month
Max. Weight:
70 lbs
Avg. Use Time:
48-90 Minutes
(depending on use)
IMPORTANT!
•Assembly of car and charging of
battery is only to be done by an
adult.
•WARNING!! NOT TO BE USED
ON STREETS OR IN TRAFFIC.
•Never modify or tamper with any
part of the electric circuit system.
This can cause permanent damage.
•Please check the vehicle
regularly for any loose parts or
wires to ensure safety and
proper operation.
•Adult supervision is recommended
during operation to avoid injury.
Safety equipment is
recommended.
•Please make sure that the child
uses caution to avoid falls and
collisions, which could cause
injury to the child or third
party.
•Do not pick up vehicle by steering
wheel.
•Do not pick up battery by wires
or charger.
•Keep all plastic bags out of the
reach of young children.
•Not recommended for children
under the age of 2 yrs. due to
small parts that could cause a
choking hazard.
•Battery must be charged for a
minimum of 8-12 hours prior to
first use of the car to avoid
damage to the battery. Power
switch must be in off position
when charging.
•Battery charger should be
examined for damage prior to
each use. It is important to
inspect the cord and both ends
for damage. If damage is
found, DO NOT USE THE
CHARGER! Contact us for a
replacement charger.
•Please keep instruction manual for
future reference.
•Please keep original packaging.
If the charger is plugged into the charging port the car will not
power on, regardless if the charger is plugged into the wall
outlet or not.

PARTS LIST
#
Name
#
Name
1
Tires
5
Steering Wheel
2
Front Axle
6
Windshield
3
Back Axle
7
Light Bar Brackets
4
Seat
8
Light Bar
All assembly videos can be found on
YouTube under SPORTrax

ASSEMBLY INSTRUCTIONS:
1: Front Axle & Tire Assembly:
Follow diagram 1 by sliding front steering rack/axle into place &
securing it from the top using a washer & lock nut. Once the
steering rack/axle is in place, install a washer onto left and right
front axles. Then slide the wheel/tire onto the axle with the hub
side of the wheel to the inside of the car. Then, install a washer and
lock nut and tighten the nut with a 17mm socket until end of axle is
flush with the outside of the nut. (Do not overtighten) Finally, snap
the wheel cover into place by lining up the tabs on the wheel covers
to the corresponding slots in the wheel.

2: Back Axle & Tire Assembly:
Disconnect & remove the rear motors from the vehicle. Slide rear
axle into place. Slide the rear motors onto axle with the motor and
connected wires are toward the inside of the car. Need to slide the
motor and wires through the round opening in the motor support
bracket mounted on the axle. It is also important to ensure the
placement of each motor to be on the correct, right/left side of the
car. NOTE: If the motors happen to get mounted on the incorrect
side during the assembly process it will make the vehicle drive in
the wrong direction. Reattach motor connections in the battery
area. Next you will need to slide the tire on the axle followed by a
washer, and lock nut. Tighten lock nuts with a 17mm socket until
the end of the axle is even with the outside of the lock nut. (Do not
over tighten) Snap wheel cover into place by lining up the tabs on
the wheel cover with the corresponding slots in the wheels.

3: Installation of Seat:
Install seat in seat location. Secure with 2 screws (provided) to
secure the seat in place.
4: Installation of Steering Wheel:
Remove the nut & bolt from the steering wheel column. Connect
steering wheel wires according to diagram. Slide the steering wheel
onto the steering shaft & secure by reinserting the bolt through the
hole in the steering wheel column and making sure that the bolt
goes through the hole in the steering shaft. It is important to make
sure that the wheels are straight and the steering wheel is straight
for the bolt to go through both items. Then install the nut to secure
the bolt from coming out when the child is driving.

5. Installation of Windshield:
Align the windshield with the vehicle & push into place.
6. Installation of Rear Light Bar Assembly:
Attach the 2 light bar corners to the light bar. Locate the light bar
corner with the power wire & hook it to the corresponding power
connector coming out of the car body. Press the light bar assembly
down into the vehicles body until it is firmly in place.

SYNCING THE REMOTE CONTROL:
Remote Control Instructions: For the first time use of remote control
or after replacing the battery, you need to sync the remote to the car.
a) Install the remote-control batteries (AAA not included).
b) Hold down forward and reverse buttons 2-4 seconds. The
Low speed LED light should be flashing.
c) Turn on the car by pressing the Power button. The Low
speed LED light should still be flashing and then turn to a
steady light if synced correctly.
d) If the syncing failed (Low speed LED light still flashing),
remove the batteries and repeat steps a –c.
e) Remote Control indicator light will go off and into power
saving mode if not used for more than 10 seconds.
f) Button Descriptions:
Forward Backward Turn Right Turn Left
S = Speed - Push button P = Emergency brake, press it once to stop the
for speed selection. motion of the car. Pressing it again will
There are 3 speed release the emergency brake, restoring the
selections to choose. functions of the car.
1 LED Light on = Low Speed
2 LED Lights on = Medium Speed
3 LED Lights on = High Speed

CHARGING THE BATTERY:
The charging port is located under the hood of the vehicle. Slide the
hood forward to expose charging port. Plug the charger into the
charging port first, and then plug the charger into a wall outlet.
Please Note: As a safety precaution and to avoid damage to the
charger, the car will not power up while charger port is plugged into
the car.
THE BATTERY MUST BE CHARGED FOR A MINIMUM OF 8-12 HOURS
BEFORE INITIAL USE AND DURING EVERY CHARGING OCCURRENCE TO
AVOID DAMAGE TO THE BATTERY. ONLY AN ADULT SHOULD CHARGE
AND RECHARGE THE BATTERY.
BATTERY REPLACEMENT AND DISPOSAL:
Over time, all batteries naturally lose their ability to hold a charge.
Depending on the amount of use and driving conditions, the battery
should function for one to three years. To replace and/or dispose of the
battery, follow these steps:
•Carefully disconnect the battery connectors.
•Remove the metal battery bracket.
•Carefully lift the battery out of the vehicle. NOTE: you may
want to wear protective gloves before removal. DO NOT lift
the battery by its connectors or cables.
•Place the used in a plastic bag.
•Reconnect the red wire to the red terminal and the black wire
to the black terminal on the new battery.
•Replace the metal battery bracket.
•Close the hood and turn the locking button on the hood to the
lock position.

WARNING:
- Use only the rechargeable battery and charger supplied with
your vehicle. NEVER substitute the battery or charger with
another brand. Using another battery or charger may cause
damage.
- NEVER modify the electric circuit system. Tampering with the
electric system may cause permanent damage to the system.
- Do not allow direct contact between battery terminals.
- Do not allow any type of liquid on the battery or its
components.
- Charge the battery in a well-ventilated area ONLY. Do not
charge near or around flammable materials.
- NEVER pick up the battery by the wires or charger. Damage can
occur to the battery and may cause a fire. Pick up the battery by
the case ONLY.
- Charge the battery in a dry area ONLY.
Wash hands after handling.
- Do not open the battery. Battery contains lead acid and other
materials that are toxic and corrosive.
- Do not open the charger. Exposed wiring and circuitry inside
case could cause electric shock. NEVER allow a child to handle
or charge the battery. Battery is heavy and contains lead acid
(electrolyte).
- Do not drop the battery. Permanent damage to the battery
could occur or cause serious injury.
- Before charging the battery, check for wear or damage to the
battery, charger, its supply cord and the connectors. DO NOT
charge the battery if any damage to parts has occurred.
- Do not allow the battery to drain completely. Recharge the
battery after each use or once per month if not used regularly.
- Do not charge the battery upside down.
-Always secure the battery with the bracket. Battery can fall out
and injure a child if vehicle tips over.
- The Power Switch must be turned in the OFF position when
charging.
- When the car begins to run slowly, recharge the battery.

GENERAL MAINTENANCE:
It is the parent’s responsibility to check main parts of the toy
before using. Regularly examine the car for potential hazard,
such as damage to the battery, charger, cable or cord, and plug,.
Also check that all screws are tightened throughout the car. In
the event of such damage, the toy must not be used until that
damage is repaired or replaced.
•Make sure the plastic parts of the vehicle are not cracked or
broken.
•Occasionally use a lightweight oil to lubricate moving parts
such as wheels.
•Park the vehicle indoors or cover it with a tarp to protect it
from wet weather.
•Keep the vehicle away from sources of heat, such as stoves
and heaters. Plastic parts may melt.
•Recharge the battery after each use. Only an adult should
handle the battery. Recharge the battery at least once a
month when not being used.
•Do not wash the vehicle with a hose. Do not wash the vehicle
with soap and water. Do not drive the vehicle in rainy or
snowy weather as water will damage the motor, electric
system and battery.
•Clean the vehicle with a soft, dry cloth. To restore shine to
plastic parts, use a non-wax furniture polish. Do not use car
wax. Do not use abrasive cleaners.
•Do not drive the vehicle in loose dirt, sand or fine gravel
which could damage moving parts, motors or the electric
system.
•For extended times when the car will not be used, the power
switch needs to be in the off position and the electrical
connections should be disconnected from the battery.

TROUBLE SHOOTING GUIDE:
Problem
Possible Cause
Possible Solutions
Car will not move
1. Battery voltage is low.
2. Battery connector or wires
are loose.
3. Battery is damaged or
dead.
4. Electrical box or motor is
damaged
Charge the battery
Re-connect the battery
connector to the car
Replace battery
Replace motor
The battery will not
charge.
1. Battery connector may
have come apart or have a
bad connection.
2. Battery charger plugged
into a bad wall outlet.
3. Battery charger is
damaged.
Re-connect the battery
connector to the car
electrical connector
Try another wall outlet
Replace battery charger
Shortened battery life
Battery was not charged fully
Battery is old
Charge battery fully
Change battery
Some Noise and heat
when charging battery
Chemical reaction
Normal
Low Speed
Battery is old
Battery is low on charge
Weight limit exceeded
Uneven or uphill path
Vehicle is being used in harsh
conditions
Change the battery
Charge the battery
Do not exceed max weight
limit
Use on flat surfaces
Avoid using car in harsh
conditions
Noise coming from
motor/gearbox
Gear in motor/gearbox broken
Call for replacement
motor
The car shakes when
moving
Bad Connection of the motor
wires
Possible motor failure
Reconnect wires
Call for replacement
motor
Car needs a push to go
forward
Poor contact of wires and/or
connectors
“Dead Spot”on motor
Check that the battery
connectors are firmly
plugged into each other. If
wires are loose around
the motor, contact the
distributor’s service
department
A dead spot means the
electric power is not being
delivered to the terminal
connection. Call our
service department
Self-Resetting Breaker –The vehicle is equipped with a self-
resetting breaker. In the event the power is tripped the breaker
will reset itself in approximately one minute.
If you are unable to solve a problem, please feel free to contact us.
Phone: [phone] or Email: [e-mail]