Supertrax Volkswagen Beetle User manual

Buggy Kids Ride on Car
Installation and Operation Instructions
Please read this instruction manual carefully. It is important to
read and follow all of the steps during assembly to ensure proper
operation and safety of the child. Please keep this manual for
future reference.
Scan this QR Code
to view the
Assembly Video

SPECIFICATIONS:
Car Type:
Volkswagen Beetle Style
Battery Type:
2*6V4.5AH
Electric Motor:
12V20W (driving motor)
Age Range:
2 –5 Years
Max. Weight:
65 lbs
Product Size:
44”L x 25”W x 16”H
Avg. Speed:
3 MPH
Charging time:
8-12 hrs
Avg. Use Time:
.75-1.5 Hrs (depending on use)
Wheel Batteries:
3 –AA (N
Remote Battery:
2 - AAA (not included)
IMPORTANT!
•Assembly of car and charging of
battery is only to be done by an
adult.
•WARNING!! NOT TO BE USED
ON STREETS or IN TRAFFIC.
•Never modify the electric circuit
system or tamper with electric
system. This can cause
permanent damage.
•Please check the product
regularly for any loose parts or
wires to ensure proper
operation.
•Adult supervision is
recommended during operation
by child to avoid injury. Safety
equipment is recommended.
•Please make sure that the child
uses caution to avoid falls and
collisions, which could cause
injury to the child or third party.
•Do not pick up vehicle by
steering wheel.
•Do not pick up battery by wires
or charger.
•Keep all plastic bags out of the
reach of young children.
•Not recommended for children
under the age of 2 yrs. due to
small parts that could cause a
choking hazard.
•Battery must be charged for a
minimum of 8-12 hours prior to
first use of the car to avoid
damage to the battery. Power
switch must be in off position
when charging.
•Battery charger should be
examined for damage prior to
each use. It is important to
inspect the cord and both ends
for damage. If damage is found,
DO NOT USE THE CHARGER!
Contact us for replacement
charger.
•Please retain instruction manual
for future reference.
•Please retain packaging in the
event it is necessary to return.
If the charger is plugged into the charging port, the car will not power
up regardless if the charger is plugged into the wall outlet or not.

PARTS LIST:
Car Body
Seat
Charger
Steering Wheel
Motor/Gearbox
Remote Control
Wheel Covers
Rear Axle
Instruction Manual
Wheels
Windshield Frame
ASSEMBLY INSTRUCTIONS:
Installing Rear Wheels &
Gearboxes
1. Apply a thin layer of grease (supplied)
uniformly onto the axle
2. Remove car from box and plastic.
3. Prop rear of car up so rear axle is off the
ground.
4. Disconnect the Right-side motor from the
power
5. Slide motor/gearbox onto the rear axle
while feeding the electrical connection
through the hole in the body into the
battery area and reconnect the electrical
connection previously disconnected.
6. Slide a rear wheel with hub onto the rear
axle.
7. Push the center button on the outside of
the wheel and push the wheel onto the
axle. Release the center button and
make sure that the wheel snaps into
place.
8. Install wheel covers onto the wheels.
9. Repeat for Left side.

Installing Front Wheels
1. Apply a thin layer of grease (supplied)
uniformly onto the axle
2. Place a washer onto the axle shaft.
3. Push the center button on the outside of
the wheel and push the wheel onto the
axle. Release the center button and
make sure that the wheel snaps into
place. Repeat for each wheel.
Installing the Windshield Assembly &
Rearview Mirrors
1. Install the windshield into the
appropriate slots in the main body, and
push in until a “click” is heard snapping
the part into place.
Installing the Steering Wheel & Back
Tail
1. Remove black plastic protective cap from
the steering shaft and discard.
2. Plug the electrical connector on the
steering wheel into the connector located
near the steering rod close to the
dashboard area. Feed the connected
wires through the hole near the steering
shaft.
3. Remove the nut from the screw located
in the steering shaft, remove the screw
from the steering shaft.
4. Install the steering wheel onto the
steering rod and secure with a screw and
nut previously removed. Install the screw
from the left side of the steering wheel,
install nut on the end of the screw and
tighten until snug against shaft of steering
wheel.
5. Put the tail into the slot on the rear of the
body and push firmly until a “click” is
heard snapping the part into place.

Installing the Seat
1. Remove the two screws.
2. Set the seat in the appropriate position
on the car.
3. Insert the two screws and tighten.

Operating the remote control
1. Install batteries
2. Press button on lower right of
left/right arrows, the red LED light
on the remote will flash.
3. Press the power button on the car to
pair the remote to the car.
4. Turn on the car, light should go solid
and will be paired to the car.
5. To power on the remote, press
button
on lower right of left/right arrows
2 TIMES, the red LED light on the
remote will be solid.
STOP Button=Parking brake
Charging the Battery:
Battery must be charged for a minimum of
8 - 12 hours prior to first use of the car to
avoid damage to the battery.
When connecting the charger, please install
the plug into the car prior to plugging
charger into the wall socket.
Only use the battery supplied with this car
to avoid damage to the car.
Adult supervision is advised for connecting
charger.
Never reverse polarity of the battery + to
red and –to black.
Never short circuit battery! Do not touch
red wires to black wires.
For remote control: it is not recommended
to use rechargeable batteries.

Vehicle stops working:
First check the fuse to see if it is burnt out
or broken. If so, replace with a new fuse.
There is a spare fuse located under the
seat.
WARNING:
- Use only the rechargeable battery and charger supplied with your vehicle.
NEVER substitute the battery or charger with another brand. Using another
battery or charger may cause damage.
- NEVER modify the electric circuit system. Tampering with the electric system
may cause permanent damage to the system.
- Do not allow direct contact between battery terminals.
- Do not allow any type of liquid on the battery or its components.
- Charge the battery in a well-ventilated area ONLY. Do not charge near or
around flammable materials.
- NEVER pick up the battery by the wires or charger. Damage can occur to the
battery and may cause a fire. Pick up the battery by the case ONLY.
- Charge the battery in a dry area ONLY.
Wash hands after handling.
- Do not open the battery. Battery contains lead acid and other materials that
are toxic and corrosive.
- Do not open the charger. Exposed wiring and circuitry inside case could cause
electric shock. NEVER allow a child to handle or charge the battery. Battery is
heavy and contains lead acid (electrolyte).
- Do not drop the battery. Permanent damage to the battery could occur or
cause serious injury.
- Before charging the battery, check for wear or damage to the battery,
charger, its supply cord and the connectors. DO NOT charge the battery if any
damage to parts has occurred.
- Do not allow the battery to drain completely. Recharge the battery after each
use or once per month if not used regularly.
- Do not charge the battery upside down.
-Always secure the battery with the bracket. Battery can fall out and injure a
child if vehicle tips over.
- The Power Switch must be turned in the OFF position when charging.
- When the car begins to run slowly, recharge the battery.

GENERAL MAINTENANCE:
It is the parent’s responsibility to check main parts of the toy before
using. Regularly examine the car for potential hazard, such as damage to
the battery, charger, cable or cord, and plug. Also, check that all screws
are tightened throughout the car. In the event of such damage, the toy
must not be used until that damage is repaired or replaced.
•Make sure the plastic parts of the vehicle are not cracked or broken.
•Occasionally use a lightweight oil to lubricate moving parts such as
wheels.
•Park the vehicle indoors or cover it with a tarp to protect it from
wet weather.
•Keep the vehicle away from sources of heat, such as stoves and
heaters. Plastic parts may melt.
•Recharge the battery after each use. Only an adult should handle
the battery. Recharge the battery at least once a month when not
being used.
•Do not wash the vehicle with a hose. Do not wash the vehicle with
soap and water. Do not drive the vehicle in rainy or snowy weather
as water will damage the motor, electric system and battery.
•Clean the vehicle with a soft, dry cloth. To restore shine to plastic
parts, use a non-wax furniture polish. Do not use car wax. Do not
use abrasive cleaners.
•Do not drive the vehicle in loose dirt, sand or fine gravel which
could damage moving parts, motors or the electric system.
•For extended times when the car will not be used, the power switch
needs to be in the off position and the electrical connections should
be disconnected from the battery.
All assembly videos can be found on YouTube under SPORTrax

TROUBLE SHOOTING GUIDE:
Problem
Possible Cause
Possible Solutions
Car will not move
1. Battery voltage is low.
2. Battery connector or wires
are loose.
3. Battery is damaged or
dead.
4. Electrical box or motor is
damaged
Charge the battery
Re-connect the battery
connector to the car
Replace battery
Replace motor
The battery will not
charge.
1. Battery connector may
have come apart or have a
bad connection.
2. Battery charger plugged
into a bad wall outlet.
3. Battery charger is
damaged.
Re-connect the battery
connector to the car
electrical connector
Try another wall outlet
Replace battery charger
Shortened battery life
Battery was not charged fully
Battery is old
Charge battery fully
Change battery
Some Noise and heat
when charging battery
Chemical reaction
Normal
Low Speed
Battery is old
Battery is low on charge
Weight limit exceeded
Uneven or uphill path
Vehicle is being used in harsh
conditions
Change the battery
Charge the battery
Do not exceed max weight
limit
Use on flat surfaces
Avoid using car in harsh
conditions
Noise coming from
motor/gearbox
Gear in motor/gearbox broken
Call for replacement
motor
The car shakes when
moving
Bad Connection of the motor
wires
Possible motor failure
Reconnect wires
Call for replacement
motor
Car needs a push to go
forward
Poor contact of wires and/or
connectors
“Dead Spot” on motor
Check that the battery
connectors are firmly
plugged into each other. If
wires are loose around
the motor, contact the
distributor’s service
department
A dead spot means the
electric power is not being
delivered to the terminal
connection. Call our
service department
Self-Resetting Breaker –The vehicle is equipped with a self-resetting breaker. In the event
the power is tripped the breaker will reset itself in approximately one minute.
If you are unable to solve a problem, please feel free to contact us.
Phone: [phone] or Email: [e-mail]