Supertrax Licensed Audi RS5 User manual

Licensed Audi RS5
Kids Ride on Car
Installation and Operation Instructions
Please read this instruction manual carefully. It is
important to read and follow all of the steps during
assembly to ensure proper operation and safety of the
child. Please keep this manual for future reference.
Scan this QR Code
to view the
Assembly Video

SPECIFICATIONS:
Car Type:
Licensed Audi RS5
Battery Type:
12V7AH
Age Range:
2 –6 Years
Max. Weight:
65 lbs
Product Size:
51”L x 28”W x 24”H
Avg. Speed:
2 –3 MPH
Charging time:
8-12 hrs –Minimum 1 Charge per month
Avg. Use Time:
1-2 Hrs (depending on use)
Remote Battery:
2 - AAA (not included)
IMPORTANT!
•Assembly of car and charging of
battery is only to be done by an
adult.
•WARNING!! NOT TO BE USED
ON STREETS or IN TRAFFIC.
•Never modify the electric circuit
system or tamper with electric
system. Can cause permanent
damage.
•Please check the product
regularly for any loose parts or
wires to ensure proper
operation.
•Adult supervision is
recommended during operation
by child to avoid injury. Safety
equipment is recommended.
•Please make sure that the child
uses caution to avoid falls and
collisions causing injury to the
child or third party.
•Do not pick up vehicle by
steering wheel.
•Do not pick up battery by wires
or charger.
•Keep all plastic bags out of the
reach of young children.
•Not recommended for children
under the age of 2 yrs. due to
small parts that could cause a
choking hazard.
•Battery must be charged for a
minimum of 8-12 hours prior to
first use of the car to avoid
damage to the battery. Power
switch must be in off position
when charging.
•Battery charger should be
examined for damage prior to
each use. It is important to
inspect the cord and both ends
for damage. If damage is found,
DO NOT USE THE CHARGER!
Contact us for replacement
charger.
•Please retain instruction manual
for future reference.
•Please retain packaging in the
event it is necessary to return.
If the charger is plugged into the charging port, the car will not
power up regardless if the charger is plugged into the wall outlet
or not.

ASSEMBLY INSTRUCTIONS:
Install front & rear wheels: Remove car from box. Remove the car from the
plastic bag. Turn car upside down. Remove the plastic axle protection covers from the
end of each axle including the longer plastic sleeve and discard. Apply thin coat of
lubricating grease (supplied) evenly over approximately 4” of each end of all 4 axles. Slide
one tire on the rear axle at each end with the hub of the tire closest to the body of the
car. While sliding on the tire, press the center of the wheel and line up the hub with the
corresponding sleeve on the gearbox. Once the tire is slid completely on the axle, release
the center button of the wheel to lock the wheel into place. Install a washer on each
front axle. Slide one tire on each front axle with the hub of the tire closest to the body of
the car. While sliding on the tire, press the center of the wheel. Once the tire is slid
completely on the axle, release the center button of the wheel to lock the wheel into
place.

Install windshield, exterior mirrors & steering wheel: Align the tabs on the
bottom of the windshield with the slots in the body of the car in the normal position of
the windshield. Press down firmly to snap the windshield into place. Put mirrors into
place on the body. Press down firmly until a clicking sound is heard, (letting you know
they have snapped into place). Connect the 2 electrical connectors between the steering
wheel and the wires from the car. Slide steering wheel onto the steering shaft. Align the
screw hole in the steering shaft and the steering wheel and slide the bolt through the
hole. Apply the nut to the end of the bolt and tighten until snug.
Connecting the Battery & Installing the Seat: Slide red wire with spade
terminal onto the red or positive (+) side of the battery. Slide the black wire with spade
terminal onto the black or negative (-) side of the battery. DO NOT INSERT THE RED WIRE
ONTO THE BLACK OR NEGATIVE SIDE OF THE BATTERY! Connect the plastic connector
from the battery to the corresponding plastic connector from the control box of the car.
Once all connections are made, align the tabs on the back of the seat with the slots in the
body of the car. Once seat is in place, flip up the seat lock located under front of seat and
slide to the side to lock the seat into place.
Steering Wheel Functions:

Remote Control Functions:
Charging the battery: The charging port is located just under the front portion of
the seat. Plug the charger into the charging port first, then plug the charger into wall
outlet. BATTERY MUST BE CHARGED A MINIMUM OF 8 TO 12 HOURS AT
LEAST ONCE PER MONTH!!!
BATTERY REPLACEMENT AND DISPOSAL:
The battery will eventually lose the ability to hold a charge. Depending on the amount of
use, and varying conditions, the battery should operate for one to three years. Follow
these steps to replace and/or dispose of the battery:
•Remove the cars seats
•Disconnect the battery connectors
•Remove the metal battery bracket
•Remove the battery cover
•Carefully lift the battery - you may want to wear protective gloves before
removal - Do Not lift the battery by its connectors or cables
•Place the dead battery in a plastic bag
•Replace the battery and reconnect the connectors
•Replace the metal battery bracket
•Replace the seat

•WARNING:
•- Use only the rechargeable battery and charger supplied with your vehicle.
NEVER substitute the battery or charger with another brand. Using another
battery or charger may cause damage.
•- NEVER modify the electric circuit system. Tampering with the electric system
may cause permanent damage to the system.
•- Do not allow direct contact between battery terminals.
•- Do not allow any type of liquid on the battery or its components.
•- Charge the battery in a well-ventilated area ONLY. Do not charge near or
around flammable materials.
•- NEVER pick up the battery by the wires or charger. Damage can occur to the
battery and may cause a fire. Pick up the battery by the case ONLY.
•- Charge the battery in a dry area ONLY.
•Wash hands after handling.
•- Do not open the battery. Battery contains lead acid and other materials that
are toxic and corrosive.
•- Do not open the charger. Exposed wiring and circuitry inside case could
cause electric shock. NEVER allow a child to handle or charge the battery.
Battery is heavy and contains lead acid (electrolyte).
•- Do not drop the battery. Permanent damage to the battery could occur or
cause serious injury.
•- Before charging the battery, check for wear or damage to the battery,
charger, its supply cord and the connectors. DO NOT charge the battery if any
damage to parts has occurred.
•- Do not allow the battery to drain completely. Recharge the battery after
each use or once per month if not used regularly.
•- Do not charge the battery upside down.
•-Always secure the battery with the bracket. Battery can fall out and injure a
child if vehicle tips over.
•- The Power Switch must be turned in the OFF position when charging.
•- When the car begins to run slowly, recharge the battery.
GENERAL MAINTENANCE:
It is the parent’s responsibility to check main parts of the toy before using. Regularly
examine the car for potential hazard, such as damage to the battery, charger, cable or
cord, and plug. Also, check that all screws are tightened throughout the car. In the event
of such damage, the toy must not be used until that damage is repaired or replaced.
•Make sure the plastic parts of the vehicle are not cracked or broken.
•Occasionally use a lightweight oil to lubricate moving parts such as wheels.
•Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
•Keep the vehicle away from sources of heat, such as stoves and heaters. Plastic
parts may melt.
•Recharge the battery after each use. Only an adult should handle the battery.
Recharge the battery at least once a month when not being used.
•Do not wash the vehicle with a hose. Do not wash the vehicle with soap and water.
Do not drive the vehicle in rainy or snowy weather as water will damage the motor,
electric system and battery.
•Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a non-
wax furniture polish. Do not use car wax. Do not use abrasive cleaners.
•Do not drive the vehicle in loose dirt, sand or fine gravel which could damage
moving parts, motors or the electric system.

•For extended times when the car will not be used, the power switch needs to be in
the off position and the electrical connections should be disconnected from the
battery.
TROUBLE SHOOTING GUIDE:
Problem
Possible Cause
Possible Solutions
Car will not move
1. Battery voltage is low.
2. Battery connector or wires
are loose.
3. Battery is damaged or
dead.
4. Electrical box or motor is
damaged
Charge the battery
Re-connect the battery
connector to the car
Replace battery
Replace motor
The battery will not
charge.
1. Battery connector may
have come apart or have a
bad connection.
2. Battery charger plugged
into a bad wall outlet.
3. Battery charger is
damaged.
Re-connect the battery
connector to the car
electrical connector
Try another wall outlet
Replace battery charger
Shortened battery life
Battery was not charged fully
Battery is old
Charge battery fully
Change battery
Some Noise and heat
when charging battery
Chemical reaction
Normal
Low Speed
Battery is old
Battery is low on charge
Weight limit exceeded
Uneven or uphill path
Vehicle is being used in harsh
conditions
Change the battery
Charge the battery
Do not exceed max weight
limit
Use on flat surfaces
Avoid using car in harsh
conditions
Noise coming from
motor/gearbox
Gear in motor/gearbox broken
Call for replacement
motor
The car shakes when
moving
Bad Connection of the motor
wires
Possible motor failure
Reconnect wires
Call for replacement
motor
Car needs a push to go
forward
Poor contact of wires and/or
connectors
“Dead Spot” on motor
Check that the battery
connectors are firmly
plugged into each other. If
wires are loose around
the motor, contact the
distributor’s service
department
A dead spot means the
electric power is not being
delivered to the terminal
connection. Call our
service department
Self-Resetting Breaker –The vehicle is equipped with a self-resetting breaker. In
the event the power is tripped the breaker will reset itself in approximately one minute.
If you are unable to solve a problem, please feel free to contact us.
Phone: [phone] or Email: [e-mail]