SW-Stahl 10587L User manual

SW-Stahl und Werkzeugvertriebs GmbH Tel. [phone] / 46438-0
Leverkuser Strasse 65 Fax [phone]
D-42897 Remscheid E-Mail: [email protected]
10587L
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL
Mounting-Tool-Set for flexible Multi Ribbed Belts
General
This set allows a damage free mounting of flexible multi-ribbed belts. These type of belts
do not require an idler, but this special tool for a convenient and gentle assembly. E.g.
suitable for following models:
• BMW: 118, 120, 318, 325, 330, 335, 520, 525, 530, 535, 635, 730, X3, X5
• Chrysler: Grand Voyager, Voyager
• Citroen: C2, C3, C4, Jumper, Relay
• Fiat: Albea, Doblo, Marea, Multipla, Ducato, Fiorino, Fiorino Qubo, Linea, Palio,
Siena, Stilo, Strada Pick Up, Lancia: Lybra
• Ford: C-Max, Focus, Mondeo, Tourneo, Transit, Courier, Fiesta, Fusion
• Iveco: Daily
• Mazda: 3, 5, Axela
• Peugeot: 206, 207, 307, Boxer
• VOLVO: C30, S40, V50
Safety advice
• Be cautious when working on hot engines: risk of burn!
• Be careful when working on running engines – loose clothes, tools and other
things can be caught up in revolving parts of the engine and cause serious harm.
• Pull the key before you start working. This way you prevent the engine from
starting up unintentionally.
• Always consult specific servicing handbooks for detailed information about the
assembly and disassembly of the multi-ribbed belt.

SW-Stahl und Werkzeugvertriebs GmbH Tel. [phone] / 46438-0
Leverkuser Strasse 65 Fax [phone]
D-42897 Remscheid E-Mail: [email protected]
10587L
www.swstahl.de
BEDIENUNG
SANLEITUNG / INSTRUCTION MANUAL
Instruction
If present, cut the old belt with an appropriate tool.
Apply tool to the belt pulley and adjust the distance bolt,
so that the tool lies flat on top of the belt pulley.
fig.1
Cock the new belt, as described in corresponding
handbooks, over all rollers and finally, as shown in the
picture, over the tool.
fig.2
Pull the multi-ribbed belt onto the crankshaft belt pulley by
turning the crankshaft.
fig.3
fig.4
With some Ford models the tool has to be attached to the
water pump as shown in fig.4 or has to be mounted on the
belt pulley of the crank shaft as shown in fig.5 to mount the
new belt.
fig.5