Takara Belmont INOVA-EX User manual

INOVA-EX
InstallationInstruction
This installation instruction is an annex of the operation manual. However, this instruction contains important
information. Please keep this installation instruction in a safe place for your future reference as well as
the operation manual.
Installation Procedure
1
Carry the chair to the predetermined position.
After removed from the pallet, the chair must
be lifted up from the floor with holding the iron
Plate below the UP/DOWN switch and then
carried with holding the base.
Base.
UP/DOWN Switch
Hold the pallet when carrying.
(If holding the upper part only, the base may drop
off. This may cause injury.)
2 Apply a rabber ring to the base.
After the chair is placed on the installation position, apply a rubber ring to the rim of the
base with lifting the base from the floor.
3 Connect the equipment to the power supply.
Use an outlet of AC 230V(7A or higher).( 220V/240V (7A or higher),110V/120V (12A or higher))
Rubber Ring
Base
Lifting one side and next the
other side of the chair will
ease the operation.
This will prevent electric shock and protect the electric circuits. If you fail to connect the earth, we will
not assume responsibility to any accident due to electric leakage.
Be sure to connect the earth.
Warning Do not lift the front portion of the seat, the seat portion will break and it may
cause bodily harm or property damage.
All manuals and user guides at all-guides.com
all-guides.com

4 Attach the step.
BB-IVFW :
Raise the legrest.
Insert the nuts of the step (back side) to the holes for nut of mounting plate.
Adjust the adjuster on the back side of step.
BB-IVFW, IVFS, IVFT :
Insert the screw of the step (back side) to the holes of mounting plate.
Fix the step with three nuts (M6).
Adjust the adjuster on the back side of step.
Loosen
Shorten
Extend
Fasten
Legrest
Mounting Plate Nut
Nut(M10)
Step Bracket
The adjuster is on the back side
Adjuster
Guide Knob
Hole for Nut
Step
Screw
After mounting the step, make sure that the mounting hardware is securely
engaged in the guide, the nuts are inserted to the holes, and there is no
wobble in the step. If there is any wobble, the step may not be stable when
your customers step up to or step down from the step. Also, when raising the
legrest, it may rub against the upper side of the step.
Make sure that the legrest is raised when mounting or detaching the step.
Care must be taken when carrying or placing the step since it is very heavy.
Falling accident may result in severe injury.
Care must be taken when extending the adjuster so that it will not touch the
power cord when the chair is rotated.
Warning
INOVA-EX
InstallationInstruction
Caution
Loosen
Shorten
Extend
Fasten
Step Mounting Pltae
Nut (M6)
Nut (M10)
The adjuster is on the back side
Adjuster
Step
1E02NHA0BOOK NO.
All manuals and user guides at all-guides.com