TEMPUR P0147104 User manual

ALTAMURA-RECLINER CHAIR (P0147104)
ASSEMBLY INSTRUCTIONS
IMPORTANT,RETAINFORFUTUREREFERENCE: READ CAREFULLY
All rights reserved © 2020 Tempur Sofa Convertibles
Made In Italy

7
2
PART # PART DESCRIPTION QUANTITYPART SKU#
A 1
N/A
ADJUSTING HEADREST POSITION
Headrest
The headrest can be manually adjusted to any desired position.
PARTS ANDHARDWARE
IMPORTANT
Avoid using sharp objectsto open packaging as you may accidentally damage the product.
Please read complete instruction sheet prior to assembly.
Minimum 2 adults required to safely perform assembly process.

63
IMPORTARTANT SAFETY INSTRUCTIONS
This recliner chair should never be left unattended when in operation.
Unplug recliner chair from outlet before relocating or troubleshooting.
Do not connect an extension cord to this unit. Plug directly into wall outlet.
Close supervision is necessary when this lift chair is used by, on
or near children, invalids, or disabled persons.
Only the occupant should operate the unit. Never attempt to open the legrest by pulling
it on.
Important: Read these instructions thoroughly before using.
WARNING
This product is not intended for use as a health care device.
Do not use outdoors. INDOOR USE ONLY.
To disconnect the power cords, change the position of lift chair to original position, then
remove plug from wall outlet.
Do not stand, sit or place extra weight on the arms, back or open legrest.
To safely exit the unit and prevent a tripping hazard bring the back upright and close the
legrest.
Do not use this product if it is damaged. Do not use attachments or subsitute components.
Provide a clear path for operation of the chair, back and legrest. Place table and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
Check the condition of the power transformers, electrical cords, plug or connector monthly.
Keep the power transformers and electrical cords away from heat sources and pinch points.
Never operate the unit with a damage power transformer, electrical cord, plug or connector.
Position of recliner that can be configured by using power button.

45
ASSEMBLY INSTRUCTIONS OPERATING YOUR UNIT
Controller
1Locate the Supply Plug Cable secured to the rear rail of the recliner chair body.
Supply Plug Cable
The controller for adjusting the backrest and legrest is located on the right side
sitting arm.
Press and hold button
to raise the legrest and recline the chair back
Press and hold button
to return to the seated position from the
reclined position
USB port
ELECTRICAL
POWER
OUTLET