TEMPUR Ardennes Headboard User manual

TEMPUR® Ardennes and Moulton Standard Divans,
and Headboards
Installation & Assemby Instructions
Fitting Castors –Unpack the base (both halves where
applicable), lay base upside down and take off attached bag
containing castors, linking bars, bolts and headboard bolts.
Place castor into the insert as shown…
Linking –Turn the bases over on to castors. Place both halves
of the base next to each other and fit silver linking bar to the
head (top) end. Fasten bolts tightly as shown…
Then repeat at foot (bottom) end of the base ….
Attaching Headboards –When fitting headboards pierce the
fabric beneath the stickers which mark where the headboard
bolt holes are. Check the bolts can thread correctly by screwing
them into the hole.

Attaching Headboards - Things To Note:
Fitting a headboard is always easier with two people.
Some models may have wooden blocks or spacers in addition to the long headboard
bolts. If they do, these go in between the divan base and the headboard. This is often
found on adjustable base units where they provide clearance for the mattresses as they
are raised and lowered on the mechanisms.
Headboards With UK Strut Fixings
1. Attach the wooden legs to the headboard using the screws provided.
2. Set the headboard bolts in the base to slightly wider than the struts so the
wooden prongs can slide over the gap between the bolt head and the base.
3. Once the headboard is in position, tighten the headboard bolts to clamp the struts
in place ensuring the headboard is secure.
Floor Standing Headboards With Bolt Slots
1. Remove the headboard bolt fixings from the head of the divan base.
2. Offer the headboard up to the headend of the bed base so the slots align with the
bolt holes.
3. Once the headboard is in position, tighten the headboard bolts to clamp the
headboard in place, ensuring it is secure.