Texecom Premier 24 User instructions

Programing the panel through keypad:
Press 1234 on the control panel. The below
message will be displayed.
Press 2 to reach “Area programming”
Press Yes
Press 11 to reach “Confirmed Reset”
Press Yes
Press NO ( X ) to edit the option & Press 0 to disable all areas, then Press Yes
Technical Support : 91520 10269 : [e-mail]
Elite Series panel
Elite 24
Elite 64-W
Elite 168
Elite 640
Press Down arrow button ( ) five times to select “Area Options”
Press 13 to reach “Anti-code Reset”
Press NO ( X ) to edit the option & Press 0 to disable all areas, then Press Yes
Premier Elite Default setting

Press 14 to reach “ATS Path Faults”
Press 16 to reach “AC Mains Fail”
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Technical Support : 91520 10269 : [e-mail]
Press 17 to reach “Arm with AC Flt”
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Press 15 to reach “Arm with No ATS”
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes

Press 18 to reach “Full Arm Coms”
Press 20 to reach “Unarm Fire Coms”
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Technical Support : 91520 10269 : [e-mail]
Press 21 to reach “Unarm Tamp Coms”
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Press 19 to reach “Part Arm Coms”
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Press 31 to reach “Bell Squawk”

Press 3 to reach “Global Options”
Technical Support : 91520 10269 : [e-mail]
Press NO ( X ) to edit the option & Press 0 to enable all areas, then Press Yes
Press NO ( X ) to change it to “Engineer Only”
Press Menu ( ) two times
Press Yes
Press Down arrow button ( ) one time to select “System Config.”
Press Yes
Press 10 to reach “User + Engineer”

Press 20 to reach “Predictive Text”
Press 34 to reach “EN50131 Enabled”
Press NO ( X ) to change it to “EN50131 Disabled”
Technical Support : 91520 10269 : [e-mail]
Press 53 to reach “PD6662:2010 On”
Press 31 to reach “Clock = 50Hz”
Press NO ( X ) to change it to “Clock = Crystal”
Press NO ( X ) to change it to “PD6662:2010 Off”
Press NO ( X ) to change it to “Manual Text Edit”

Press Menu ( ) three times on the control panel and then press Yes to logoff
from your control panel
If there are any ‘System Alerts’, press 5678 and press Reset button to clear
the alerts. Your system is now set up.
Technical Support : 91520 10269 : [e-mail]