Toro 110-5076 User manual

Form No. 3354-831 Rev A
Footswitch Upgrade KitFor Multi-Pro 5600 Turf SprayerModel No. 110-5076
Installation Instructions
Installation
Loose PartsUse the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Remove the foot switch.
Floor switch
1
Wiring harness
1
Hex-head screw (1/4 inch)
2
Lock washer (1/4 inch)
2
Nut (1/4 inch)
23
Wire tie
4
Install the oor switch.
Step
1
Preparing the Machine
No Parts Required
Procedure
1. P ark the spra yer on a flat surface , lo w er the
booms , set the parking brak e , stop the engine ,
and remo v e the k ey .
2. Disconnect batter y neg ati v e cable .
Step
2
Removing the Foot Switch
No Parts Required
Procedure
1. Disconnect Spra yer F oot Switc h connector
under floor pan.
2. R emo v e the retaining n ut and remo v e the
spra yer foot switc h from the floor pan. Discard
the foot switc h.
3. R emo v e the bolt securing the left side of
the front hood to the floor pan to allo w the
existing floor switc h wiring to be brought
abo v e the floor pan ( Figure 1 ).
© 2005—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)Printed in the USA.All Rights Reserved

Figure 1
1. Front hood, left side 3. Bolt2. Floor pan 4. Existing oor switch wiring
4. After the wiring is abo v e the floor pan reinstall
the front hood and secure it with the co v er
bolt.
Step
3
Installing the Floor Switch
Parts needed for this step:
1
Floor switch
1
Wiring harness
2
Hex-head screw (1/4 inch)
2
Lock washer (1/4 inch)
2
Nut (1/4 inch)
4
Wire tie
Procedure
1. Place the new floor switc h in the area as sho wn
in Figure 2 , near the old switc h location, and
use the switc h to mark locations for drilling
holes .
2. R emo v e the new switc h and drill tw o 1/4 inc h
holes in the floor pan at drill points mark ed in
the previous ste p .
3. Mount the new floor switc h using the tw o
hex-head screws (1/4 inc h), tw o loc k w ashers
(1/4 inc h) and tw o n uts (1/4 inc h) pro vided in
loose par ts ( Figure 2 ).
Figure 2
1. New oor switch
3. Lock washer (1/4 inch)2. Hex head screw (1/4 inch) 4. Nut (1/4 inch)
4. Connect the three prong connector on the
new wiring har ness to the three prongs on the
floor switc h.
5. Connect the old floor switc h connector to the
matc hing connector on the new wiring har ness
( Figure 3 ).
Figure 3
1. New oor switch,connected to wiringharness
3. Wire ties
2. Old wiring harness,connecting to new wiringharness 4. New wiring harness andrelays, secured to frame
2

6. Use wire ties to secure the rela ys and har ness to
the frame under the dash as sho wn in ( Figure
3 ).
7. R econnect the batter y .
8. T est for proper floor switc h function.
3