Town & Country Fireplaces King-TC User manual

311008-2 EUROPEAN COPPER DECORATIVE CAP 5056.425212
EuropEan CoppEr DECorativE Cap
Models: King-TC, Pawn-TC, Bishop l-TC & Bishop ll-TC
For Direct Vent Termination Caps
European Copper Decorative caps.
Models King-TC, Pawn-TC, Bishop I-TC
and Bishop II-TC have been tested and are
approved for use with all Town and Country
replaces that are vented vertically through
the roof.
Only models with the “TC” extension will t
Town and Country Terminals.These shrouds
are designed with the cap internal shield re-
moved to allow the “TC” Termination Cap to
t up inside the shroud cap.
Check with your local building code agency
before you begin installation to ensure com-
pliance with local codes including the need
for permits and follow-up inspections.
PAWN-TC
KING-TC
24.00"
20 5/8"
25 3/4"
47 3/4"
Fig #1
Fig #3
Fig #2
Fig #4
38 5/8"
BISHOP l-TC
BISHOP ll-TC
26.00"
52 1/16"
20"

311008-2 EUROPEAN COPPER DECORATIVE CAP 5056.425212
TC TERMINATION CAP
TC VENT PIPE
NON-COMBUSTIBLE
CHASE TOP
*
Fig #5
Installation
1. Install the vent system as per instal-
lation instructions supplied with the Town
and Country replace. The vent pipe must
extend the specic height above the chase
top as shown in the table. If it extends high-
er, the decorative cap will not t over-top of
the terminal, and if shorter, the replace will
not operate safely. Place an appropriately
sized ashing and storm collar over the vent
pipe and seal. Ensure the ashing size will
not impede the installation of the decorative
shroud.
2. Remove weather shield/rain cap from
chimney pot base if attached. Save screws
for later re-attachment. (Fig #6)
3. Attach all 8 mounting brackets to chim-
ney pot base with carriage bolts, washers, &
lock nuts.
Position chimney pot over vent, make sure
pot is centered. Level chimney pot by adjust-
ing brackets as necessary. When chimney
pot is level, tighten nuts to secure brackets
in place. Mark bracket hole locations on
chase top. Remove chimney pot and drill
holes in marked locations. Set ashing gas-
kets over each drilled hole with vinyl side
up. Set chimney pot in place with brackets
on gaskets. Anchor pot to chimney top with
correct fasteners. Tighten each fastener se-
curely. Caulk all fasteners connecting the
chimney pot to the top of the chimney.
4. Lower the Town and Country roof vent
termination cap over the vent pipe and se-
cure in place with screws provided. Seal
the screw heads and joint with caulking to
prevent any moisture entering the vent sys-
tems.
5. Lower weather shield/rain cap over
the Town and Country Termination Cap and
attach to chimney pot base with screws pre-
viously removed.
Model Dimensions
above chase top
King-TC 39 "
Pawn-TC 17"
Bishop l-TC 40 1/2"
Bishop ll-TC 27 1/8"
(See dimensions
in table below)
*
(KING-TC Shown)
WEATHER SHIELD/RAIN CAP
CHIMNEY POT BASE
MOUNTING BRACKETS
Fig #6
NOTE:
The mounting brackets are
designed to allow for drainage.
DO NOT add grout or sealant around
the base of the chimney pot.