TP-Link KLM100 User manual

KLM100 User Manual
1. Overview
The KLM100 Wi-Fi module provides a highly-integrated and flexible platform for
developing and evaluating products and applications based on the MT7682 SoC. The
KLM100 Wi-Fi module can be either used with development kit for software development
or incorporated into OEM products to enable rapid deployment of Wi-Fi connected systems.
The module includes the following components:
MT7682SN chip
A printed antenna
Shield
2. Interface and pinout
Interface:
Debug UART
PWM x4
Pinout:

3. Electric Feature
Power Supply
Type
DC
Input
3.3V0.3A
Typical
300mW
Standby Mode
125mW
4. Mechanic Feature
Size: 24.00mm*19.00mm*2.60mm
5. Wireless Feature
Operating Frequency:2.4GHz:2412~2462MHz
Transfer Rate: 802.11b: 11/5.5/2/1 Mbps
802.11g: 54/48/36/24/18/9/6 Mbps
802.11n HT20: up to 65Mbps
Wireless Channel: ch1-ch11
Transmit Power:18dBm(max)
Antenna Type: Printed omnidirectional antenna
6. Physical and Environmental
Operating Temperature: -15℃～85℃
Storage Temperature: -15℃～85℃
Working Humidity: 10%～90% RH
7．Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:

(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This transmitter module must not be co-located or operating in conjunction with
any other antenna or transmitter.
The module should be installed in LED lamp.
This End equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following:
“Contains FCC ID :TE7KLM100”.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module.