TP-Link TL-SM331T User manual

Installation Guide
©2021 TP-Link 7106509374 REV1.0.0
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
If you have any suggestions or needs on the product guides,
welcome to email [e-mail].
To ask questions, find answers, and communicate with TP-Link
users or engineers, please visit https://community.tp-link.com
to join TP-Link Community.
RJ45 SFP Module
Install the RJ45 SFP Module
1. Lock the yellow latch into place and insert the module into an SFP slot with label side up.
2. Gently push the module into the slot until you hear a click. Then, insert the RJ45 network cable.
Remove the RJ45 SFP Module
1. Press the RJ45 crystal head and pull out the cable.
Note: Images may dier from the actual products.

Specications
Compatiblity
We recommend that you use only TP-Link modules on your
TP-Link devices.
Note:
*TL-SM331T does not support the data rate of 10 Mbps or 100 Mbps.
**When a gigabit RJ45 SFP module is inserted into a 10G SFP+ slot, extra
conguration for port data rate may be required.
https://www.tp-link.com/support/download/tl-sm331t/#Compatibility
To check the compatible TP-Link devices of your module,
please scan the QR code or visit our website:
Product Operating Temperature 0˚C to 70˚C (32˚F to 158˚F)
Storage Temperature -40˚C to 85˚C (-40˚F to 185˚F)
Storage Humidity 5% to 90% RH, Non-condensing
Operating Humidity 10% to 90% RH, Non-condensing
Environmental and Physical SpecicationsGeneral Specications
RX_LOS
MAC Interface
Power Consumption (max.)
Standards and Protocols
Model
Data Rate* (max.)
TX_Fault
TX_Disable
Hot Swappable
LLF
LFP
Cable Distance
DDM
0.8 W
/
/
Ye s
Ye s
/
/
1000BASE-X
1.25 Gbps
TL-SM331T
1000BASE-T: UTP
cat.5e or above
(max. 100m)
/
IEEE 802.3
IEEEE 802.3ab
SFF-8472
Model
SupportedGigabit SFP Slot (SFP Slot)
TL-SM331T
Supported**10G SFP+ Slot (SFP+ Slot)
2. Pull down the latch and remove the module.
Safety Information
Keep the device away from water, re, humidity or hot environments.
Do not attempt to disassemble, repair, or modify the device. If you need
service, please contact us.
Avoid using this product during an electrical storm. There may be a remote risk
of electric shock from lightning.
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/30/EU,
2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at
https://www.tp-link.com/en/support/ce.
EU Declaration of Conformity
UK Declaration of Conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of the Electromagnetic Compatibility
Regulations 2016 and Electrical Equipment (Safety) Regulations 2016.
The original UK Declaration of Conformity may be found at
https://www.tp-link.com/support/ukca

この装置は、クラスA情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがあり
ます。この場合には使用者が適切な対策を講ずるよう要求されることがあります。 VCCI-A
FCC compliance information statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Product Name: RJ45 SFP Module
Model Number: TL-SM331T
Responsible party:
TP-Link USA Corporation, d/b/a TP-Link North America, Inc.
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: [phone]
Fax: [phone]
E-mail: [email protected]
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply
with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment
and the equipment is properly maintained and operated.
Issue Date: 2021/09/14
This is a class A product. In a domestic environment, this product may cause radio interference, in which case
the user may be required to take adequate measures.
CE Mark Warning
BSMI Notice
安全諮詢及注意事項
請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。
注意防潮，請勿將水或其他液體潑灑到本產品上。
插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。
請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。
請不要私自拆開機殼或自行維修，如產品有故障請與原廠或代理商聯繫。
此為甲類資訊技術設備，于居住環境中使用時，可能會造成射頻擾動，在此種情況下，使用者會被要求採取某
些適當的對策。
Explanation of the symbols on the product label
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU
in order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer when
he buys a new electrical or electronic equipment.
Note: The product label can be found at the bottom of the product.
限用物質含有情況標示聲明書
產品元件名稱
PCB
外殼
產品元件名稱
PCB
外殼
限用物質及其化學符號
備考： "○"系指該項限用物質之百分比含量未超出百分比含量基準值。
鉛
Pb
○
○
鎘
Cd
○
○
汞
Hg
○
○
六價鉻
Cr+6
○
○
多溴聯苯
PBB
○
○
多
溴二苯醚
PBDE
○
○
CAN ICES-3 (A)/NMB-3(A)
Industry Canada Statement
Indoor use only
Caution
Operator’s manual