Travis Industries 4237 User manual

4237 IronWorks Face
Bronze 95900732
Page 1 of 2 17601941 - Printed 8/22/16 © Travis Industries, Inc.
Compatibility
4237 Fireplace
Packing List
Backing Plate
Doors (left and right)
(18) #8 x 3/8” Pan Head Screws
Sizing (dimensions are of the backing plate, which is slightly larger then the doors)
Width Height * Minimum Facing Depth Maximum Facing Depth
Ironworks Face 45.625” 39.25” * 1/2” 1”
* The bottom of the face, when installed, is 1” above the base of the fireplace.
Installation
NOTE: The backing plate replaces the tile stop on the fireplace (if installed, remove and discard the tile stop).
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1 The backing plate is attached after the fireplace is in place with the non-combustible facing installed.
2 Remove the glass screen (and appliance trim) from the fireplace (see the manual for details).
3 Attach the backing plate to the fireplace with the included screws. When tightening the screws, push the
backing plate against the facing to ensure a seamless fit.


4237 IronWorks Face
Bronze 95900732
Page 2 of 2 17601941 - Printed 8/22/16 © Travis Industries, Inc.
4 Hang the doors on the backing plate (see pictures below). When closing the doors, make sure to bring them
together at the same time to ensure proper alignment.
NOTE: Magnets are shipped attached to the face. Take care with the magnets and keep them away from children.
NOTE: If the magnets become dislodged from their position in the face, carefully re-install them.