Travis Industries 98500668 User manual

21 DV Firebox Interior
Travertine 98500668 – Brick 98500669
Page 1 of 2 Printed 10/15/03 © Travis Industries, Inc.
Compatibility
-- 21 DV Fireplace
Packing List
Firebox Liner
Important Warnings
• Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
• The firebox liner is fragile – take care to prevent damage.
• The firebox liner leaves a slight white residue when touched – make sure to clean the area and
your hands after handling the liner.
Installation
1 Remove the face, glass, embers, and burner (see the owner’s manual for details).
2 Follow the directions below to remove and discard the steel liner.
Lift the back of the liner so the
tab disengages from this slot
on the niche shelf.
a
b
c
Push the
bottom edge
of the liner to
the back of
the firebox.




Steel Liner Liner
Liner Shelf
Tilt the steel liner forward and pull it out of
the firebox (pull the top edge out first).

21 DV Firebox Interior
Travertine 98500668 – Brick 98500669
Page 2 of 2 Printed 10/15/03 © Travis Industries, Inc.
3 Install the liner following the directions below.
(a) Tilt the liner
forward and at a
slight angle as you
insert it into the
firebox.
Place the bottom
left corner into the
firebox first.
(b) As you insert
the liner, make
sure the liner
goes behind the
pilot assembly.
(c) The top of the
liner will be very
tight along the top
– carefully rotate
and tilt the liner
into place.
(d) Once in the
firebox, pull the
liner forward so it
is against the front
flanges of the
firebox. Center
the liner from side
to side.
4 Replace the burner, logs, embers, glass, and face.