Travis Industries 94700881 User manual

Xtreme 6020 Birch Log Set
(sku 94700881)
Page 1 of 2 17601612 - Printed 5/3/10 © Travis Industries, Inc.
The logs are made of a ceramic material that is FRAGILE. Carefully handle each log with both hands.
Overview
This log set is for use with an Xtreme 6020 that has been pre-configured for use with logs. The threaded stud
plates are pre-installed to suit these instructions.
Packing List
(2) #1 Logs
(3) #2 Logs
(2) #3 Logs
(3) #4 Logs
(3) #5 Logs
Log Configuration
The logs are arranged in the pattern shown below.
Log Installation
NOTE: The logs should be installed after the fireplace has been installed and tested for proper operation and
before installing the crushed glass.
NOTE: Remove the ¼” hex bolts on the end of each log. These bolts protect the threads during manufacture.
1. Each log has an identification # marked on the bottom (see photo below). Note the press nut on the
bottom of the log. This nut threads over the threaded studs on the stud plates.

Xtreme 6020 Birch Log Set
(sku 94700881)
Page 2 of 2 17601612 - Printed 5/3/10 © Travis Industries, Inc.
2. Starting at the front right log, carefully insert each log into the firebox and spin into position (see photos
below). Do not over-tighten the logs. They should be tightened just enough to remain secure.
3. Continue to install the remaining logs, referring to
the illustration on page 1 for log placement.
HINT: Each log may be placed vertically, or at a
slight angle up to 10˚from vertical to create an
aesthetic arrangement. See the photo to the right
for a typical installation.
NOTE: The log set affects airflow inside the fireplace.
Adjust the air shutters to fully open position
prior to placing the glass. After operating the
fireplace to insure proper flame performance,
the air shutters may be closed slightly if
needed.
4. Once all the logs are in place, install the crushed
glass media over the perforated steel (see photo
below). Make sure the crushed glass covers the
stud plates but does not cover the pilot (see
manual for complete details).
5. Replace the glass frame and start the fireplace. Let the fireplace burn for 30 minutes on high and check
the logs for sooting. Remove the glass and carefully inspect the areas above the burner for soot
accumulation. If any soot is detected, re-adjust the log and repeat this step to insure no sooting occurs.