Travis Industries 250-05727 User manual

This kit is for replacement of the incorrect exhaust restrictor that was inadvertently packaged on some of
the 564 25K GSR2 and 564 25K GSR2 CF fireplaces. The included “flat” restrictor will not work correctly
and needs to be replaced with the exhaust restrictor included in this kit.
AFFECTED SKU NUMBERS:
98500277, 98500278
AFFECTED SERIAL NUMBER RANGE:
3409-043397 through 3409-044388
Appliances that are installed straight out the back or with a minimum rise that require the exhaust restrictor
to be removed according to the installation instructions need no action taken. The exhaust restrictor does
not need to be replaced - simply removed - on these types of installations.
All other installations need to have the “incorrect” exhaust restrictor changed out.
INSTRUCTIONS:
1. Remove the old “incorrect” exhaust restrictor by removing the (2) 1/4” hex head screws holding it in place.
2. Install the new “correct” exhaust restrictor in it’s place using the (2) 1/4” hex head screws removed in step
#1.
IMPORTANT - be sure to set the exhaust restrictor in the proper position for your specific vent configuration
(refer to the installation manual for detailed information on configurations).
Thank you for your attention to this issue. We apologize for any inconvenience this may have caused. Please
don’t hesitate to contact us with any question.
564 25K Exhaust Restrictor Kit
250-05727
© Travis Industries, Inc.
17602205
Page 1

FOR REAR VENT APPLICATIONS WITH NO VERTICAL RISE ONLY
•When using a rear vent configuration with no vertical rise remove and discard the exhaust restrictor and
install the exhaust deflector (included with the fireplace) as shown below.












Remove and
discard the
exhaust restrictor
(keep the screws).
Install the exhaust
deflector using the
screws removed
earlier. Note how it
angles upwards
and fits into the
exhaust box.
3 feet
915mm
0 feet
mm
0 feet mm
1' (max) 300mm
- Remove the Exhaust Restrictor
and Install Exhaust Deflector
- Intake Restrictor # 1 (stock)
- Diffuser Position # 1 (stock)
• Max. 12" (102mm) Horizontal Section
• No Elbows Allowed
© Travis Industries, Inc.
17602205
Page 2

Approved Vent Configurations
Restrictor Position
Intake and exhaust restrictors are built into the appliance to adjust the flow rate of intake air and
exhaust gases. Depending upon the vent configuration, you may be required to adjust the restrictor
positions. The charts for acceptable vent configurations detail the correct vent restrictor positions.
Exhaust Restrictor Adjustment
If the diffuser is required to be in position # 2, you may wish to adjust the diffuser while the exhaust
restrictor is removed.
NOTE: If removing the restrictor, make sure to replace the screws in the firebox ceiling.













Loosen these 2 screws on
the exhaust restrictor.
Slide the restrictor to the correct
position (see illustration above).
The rear screw location indicates
restrictor position.
Back Wall of Firebox
Firebox Roof
WHEN USING POSITION #4 (OR GREATER
BEND THIS FLANGE DOWN FLAT
(closed)# 4
# 3
# 2
(open) # 1
This restrictor is in position # 4.
Tighten the screws to secure the
restrictor.
NOTE: These obround holes allow
for the restrictor to be removed
with the screws still in place.
© Travis Industries, Inc.
17602205
Page 3