Travis Industries 96100594 User manual

Revere / 1750i 1 Piece Surround Panel
See SKUs Below

Page 1 of 2 17601908 - Printed 10/5/15 © Travis Industries, Inc.
SKUs
Height Width
Custom Panel 96100594 Custom Custom
Small Panel 96100443 28.5” 40”
Medium Panel 96100444 30.5” 42”
Packing List
Panel
Left & Right Panel Mounting Brackets
(6) 10-24 Pan Head Screws

(6) 10-24 Nuts
Drill Bit
Installation
1. The insert should be in position, but pulled out slightly to allow access to the sides and top of the insert.
2. Attach the side brackets to the side of the insert following the directions below.
REVERE
Attach the brackets using the studs on the side
convection fronts and the nuts included with the panel.

1750i
Attach the brackets using the screws and nuts
included with the panel.
The brackets are not symmetrical.
Make sure to use the correct side
bracket (make sure the notch is at the
bottom).

Revere / 1750i 1 Piece Surround Panel
See SKUs Below

Page 2 of 2 17601908 - Printed 10/5/15 © Travis Industries, Inc.
3. Use the included drill bit to drill a hole into the top convection channel as shown in the illustration below.
Use the included screws and nuts to fully secure the side brackets.
4. Place the insert into position (flue attached). Attach the surround panel as shown below.

Use the bracket as a template to
drill the upper mounting hole
(use included drill bit). Secure
the bracket using the screws and
nuts included with the panel.
