Travis Industries Olympic User manual

Olympic 1 Piece Surround Panel
See SKUs Below

Page 1 of 2 17601905 - Printed 10/6/15 © Travis Industries, Inc.
SKUs
Height Width
Custom Panel 96100591 Custom Custom
Small Panel 96100464 30.5” 42”
Medium Panel 9600465 34” 44”
Packing List
Panel
(2) Panel Mounting Brackets
Upper “L” Bracket
(4) 10-24 x ½” Thread-Cutting Screws
(2) 10-24 Nuts
(2) 10-24 x ½” Machine Screws (Truss Head)
Drill Bit
Installation
1. The insert should be in position, but pulled out slightly to allow access to the sides and top of the insert.
2. Attach the side bracket to the side of the insert using the thread-cutting screws as shown below (both
sides) – make sure to use the correct holes (cooktop or standard).
NOTE: The brackets have slotted holes. Align the brackets flush with the front of the convection chamber
before tightening the screws.
Make sure to use the correct mounting holes. If using the top air chamber extension,
use the forward holes, if not (cooktop version) use the rear holes.
Button Plugs
(pry out with a screwdriver) 5/16" Nutdriver
Attach the brackets with the
included screws.
Hint: pre-thread the holes
prior to installing the brackets.

Olympic 1 Piece Surround Panel
See SKUs Below

Page 2 of 2 17601905 - Printed 10/6/15 © Travis Industries, Inc.
3. If using the top air chamber extension, disregard this step and go to step 4. When using the cooktop
version (no air chamber extension), position the “L” bracket so that is flush with the front edge of the stove
top. Use the bracket as a template to drill two mounting holes through the stove top (use included drill bit.
Secure the bracket with the included machine screws and nuts (remove the grill to install).
4. Place the insert into position (flue attached). Attach the surround panel as shown below.