TRIBU D2175-x-T User manual

T-Table
ASSEMBLY INSTRUCTIONS
D2175-x-T / D2176-x-T
D2177-x-T / D2178-x-T
D2179-x-T / D2180-x-T
TTTT05 - 10 - 08-02-2022
Tribù nv
Oude Heidestraat 72
3740 Bilzen
BELGIUM
www.tribu.com
[email protected]
Put the tabletop on top of the assembly and x with 4 x small washer and 4 x screw.
Use an Allen key and apply normal force. DON’T USE A POWERTOOL.
You can use the adjustable feet to level the table.
5
6
Attention: Never move the table when it is assembled. In case the table has to be moved to a
new location, always dismantle the top from the base to avoid damages.

CONTENT ASSEMBLY INSTRUCTIONS
1 x
Tabletop round/square
1 x
Base
1 x
Nut
4 x
1 x
Top mount
1 x
Leg
2 x
Large washer
1 x
Threaded rod
4x washer
T-Table is available in 3 table heights. Make sure you combine the correct threaded
rod with the correct leg. The threaded rod is a little bit longer than the leg.
These components are packed together.
H35 H67 H75
Place the base in the designated location on a level surface and insert the threaded
rod. Make sure the welded nut is facing downwards. Use the large washer. Make sure
to tighten with a wrench.
Position the leg over the thread rod. Make sure it ts into the base.
The 4 pins on the bottom side of the leg t into 4 designated holes.
1
2
3
4Position the top mount on the leg and x with 1 x large washer and 1 x nut.
Use a wrench to tighten with maximal force.