TRIBU 07661 User manual

Tribù nv
Langendijkstraat 5a
3690 Zutendaal
BELGIUM
www.tribu.com
[email protected]
Assembly instructions
07661-XX-XX
07660-XX-XX
BRANCH TABLE ø70 - ø80
BRDT0103 –03/02/2015
Put the gliders in place.
7

Content Assembly Instructions
3 x glider
1 x Tabletop ø80
3 x leg 1 x connection
3 x Slot-nut
3 x bolt a (headless)
6 x bolt long (2cm)
Set the Slot-nut in place as in the picture
below.
1Slice the connector in place and
screw with bolt a. DO NOT screw
completely tight.
2
While pushing the leg towards the
center of the table, screw bolt a (see
step 2) completely tight for each leg.
6
Put the tabletop upside down onto
another table and put the pre-
assembled legs in place. WARNING : Put
a cloth or foam in order to protect the
tabletop from scratches.
4
Repeat step 1 and 2 for the other 2 legs.
3
Screw the legs in place with bolt
LONG or SHORT. WARNING: Use the
correct bolt with the correct top.
5
6 x bolt short (1,2cm)
TABLETOP BOLT
ALUMINIUM LONG
(2 cm)
TEAK LONG
(2 cm)
GRANITE SHORT
(1,2 cm)
ATTENTION
Do not use electrical equipment to
tighten the bolts in the tabletop.