TRIBU D2175 Series User manual

T-Table
ASSEMBLY INSTRUCTIONS
D2175-x-x / D2176-x-x
D2177-x-x / D2178-x-x
D2179-x-x / D2180-x-x
TTRT05 - 10-08-2022
Tribù nv
Oude Heidestraat 72
3740 Bilzen
BELGIUM
www.tribu.com
[email protected]
You can use the adjustable feet to level the table.
Put the tabletop on top of the assembly and make sure it is centered. The headend should stick
out 18.5 cm on each side. The side of the table should stick out 19 cm on each side.
5
6
Attention: Never move the table when it is assembled. In case the table has to be moved to a
new location, always dismantle the top from the base to avoid damages.

CONTENT ASSEMBLY INSTRUCTIONS
1 x
Tabletop
2 x
Base
2 x
Nut
2 x
Leg
4 x
Large washer
2 x
Threaded rod
T-Table is available in 3 table heights. Make sure you combine the correct threaded
rod with the correct leg. The threaded rod is a little bit longer than the leg.
These components are packed together.
H35 H67 H75
Place the base in the designated location on a level surface and insert the threaded
rod. Make sure the welded nut is facing downwards. Use 1x large washer. Make sure to
tighten with a wrench.
Position the leg over the thread rod. Make sure it ts into the base.
The 4 pins on the bottom side of the leg t into 4 designated holes. Repeat this step for the 2nd
base.
1
2
3
4Position the top mount on the leg and x with 1 x large washer and 1 x nut.
Use a wrench to tighten with maximal force.
1 x
Frame