TRIBU VISAVIS 01753 User manual

Tribù nv
Oude Heidestraat 72
3740 Bilzen
BELGIUM
www.tribu.com
[email protected]
Assembly instructions
01753
VISAVIS Table 300x99cm
Slide the supports into each other in order to put the 2 tables together.
7
Turn the table carefully upside up.
Place the third table top onto the supports between the 2 other table tops and screw it with
4 bolts B.
9
1
2
Take 3 bolts C and screw them into the holes to connect the supports as shown in the
picture below. Screw them in alternating way.
Repeat this step for the other side of the table.
8
VAVDT02/01 –16/03/2015
MANUAL 2

Materials Assembly Instructions
Assemble one set legs on one table top (use 8 bolts A + 8 washers) as described in the
assembly instruction of the Vis a Vis Table 1m (01773).
1
Assemble the other set legs on another table top (use 8 bolts A + 8 washers) as
described in the assembly instruction of the Vis a Vis Table 1m (01773).
4
Leave the table upside down and take one left support B. Assemble the support
with 2 bolts b onto the table top as shown in the picture below. Mind that the 3
holes A of the support are directed to the inside of the table.
2
Leave the table upside down and take one left support A. Assemble the support with 2
bolts b onto the table top as shown in the picture below. Mind that the 3 holes A of the
support are directed to the inside of the table.
3
3x Table top
4x leg
4x support for leg
16x dowel 6x bolt C (25mm)
1x left support A
1x right support A
1x left support B
1x right support B
12x bolt B (80mm)
Holes A
Holes A
Leave the table upside down and take one right support B. Assemble the support
with 2 bolts b onto the table top as shown in the picture below. Mind that the 3
holes A of the support are directed to the inside of the table.
5
Leave the table upside down and take one right support A. Assemble the support with
2 bolts b onto the table top as shown in the picture below. Mind that the 3 holes A of
the support are directed to the inside of the table.
6
16x bolt A (80mm) 16x washer
Make sure you assembled all the single tables as mentioned in manual 1