TRIBU UKIYO 07553 Series User manual

UKIYO DINING TABLE
ASSEMBLY INSTRUCTIONS
UKDT01 - 12-10-2022
07553-xx

COMPONENTS
TABLE TOP
teak
TABLE TOP
ceramic
OVAL BEAM 2x LEG
SHORT
SCREW
HEADLESS SCREW
already preassembled
WOODSCREW
Hardware:
TABLE TOP FRAME
2x RECTANGULAR BEAM
LONG
SCREW

ASSEMBLY INSTRUCTIONS
Fit the 1x leg onto the rectangular beams. Match the letter on the legs
with the letter on the rectangular beams. A - A, B - B.Use 2x long screws
for each rectangular beam to secure it to the leg.
Slide the oval beam onto the metal studs of the legs. Make sure the holes
in the oval beam face upwards. ALWAYS MAKE SURE THE OVAL BEAM
STAYS HORIZONTAL TO AVOID DAMAGE.
1
2

Slide the the metal studs of the legs into the designated holes on the oval
beam. ALWAYS MAKE SURE THE OVAL BEAM STAYS HORIZONTAL TO
AVOID DAMAGE.
Use 2x long screws for each rectangular beam to secure it to the leg.
3
4

Secure the oval beam to the legs by tightening the headless screw, 2x
headless screws / each leg. The headless screws are already preassem-
bled.
5
Flip the assembled legs into an upright position.
6

Lower the frame onto the already assembled legs. Secure the frame to
the assembled legs using short screw.
7
If you want to assemble a teak table top move forward to step
If you want to assemble a ceramic table top move forward to step
89
11

Remove all bumpons by turning the woodscrews counterclockwise.
9
Lower the teak table top in the frame. Secure the teak table top to the
frame using wood screws. Tighten the woodscrews clockwise.
10
Assembly teak table top

Remove all metal brackets by turning the woodscrews counterclockwise.
11
Assembly ceramic table top
Lower the ceramic table top into the frame. Make sure the gap between
the ceramic table top and the frame is equal all around
12

Tribù nv
Oude Heidestraat 72
3740 Bilzen
BELGIUM
www.tribu.com
[email protected]