Turnigy Eagle-3D User manual

CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
performance to full extent .
Wing span:57.4in/1460mm;
Wing area:58sq.dm;
Length:55in/1400mm;
Weight:1950g;
Engine:2-Cycle 40-46;
Radio:4channels 5servos;
P1

Connect the main wing and
the aileron with hings, and
glue them to ensure its
safty.
Cut holes for the servo.
Prepare two servos and
extension comparatively.
MAIN WING
P2

Put the servo into the hole,
and drill holes for the
servo screw.
Fix the tri-horn at the
right position, and connect
it to the servo by pushrod.
Pull the servo extension
out from the holes in the
main wing.
P3

Join the main wing to the
fuselage with carbon joiner.
Fixup the mian with nylon
screw.
Connect the aileron and the
elevator by hings and glue
them.
Insert the small wood part,
and glow it to the fuselage
to fixup the stabilizer.
TAIL WINGS
Nylon Screw
factory
provided.
P4

Glue the vertical fin to
the fuselage.
Drill hole for the tail
wheel landing gear to
insert into the rudder.
Insert the tail wheel
landing gear into the
rudder and glue it.
RUDDER AND TAIL WHEEL
P5

Connect the vertical fin
and the rudder by hings and
glue them together.
Fixup the tail wheel to the
fuselage by four TP screws
as shown.
Find out and cut the hole
for the rudder servo.
P6

Install the rudder servo
as shown.
Find out and cut the hole
for the elevator servo.
Install the elevator servo
as shown.
P7

Fixup the wheel,wheel cover
and the landing gear
together.
Screw the landing gear to
the fuselage by 3 screws.
Gather the parts for the
fuel tank together.
MAIN LANDING GEAR
FUEL TANK
P8

Install the fuel tank as
shown.
Put the fuel tank into the
right position.
Finished photo for the fuel
tank.
P9

Install the engine mount.
The firewood to airscrew
sould be 118mm.
Find out the motor mount
and install the motor then.
ENGINE & MOTOR
P10