Turnigy Katana-15 Operation instructions

Wing Span:42.3in/1075mm Flying Weight:900-1000g
Wing area:21sq.dm Radio:4channels 5servos
Length:33.9in/860mm
CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
Engine:2cycle 15-25
performance to full extent .

Cut away covering film for
the servo.
Put the servo into the
hole.
Pull out the servo
extension from main wing.
Install The Aileron Servos

Connect the aileron and
the main wing by hinges.
Be sure to apply instant
type glue to both sides
of each hinges.
Bent the pushrod as shown.
Link the servo and
tri-horns with pushrod and
straper.

Find out the holes on each
sides of the fuselage as
shown.
Connect the main wings and
the fuselage with joiner.
Use two 5mm screws of each
sides to ensure the wings
fixed upto the fuselage.
Connect the aileron and the
stabilizer by hings, and
glue them.
Join The Wing
Install The Rudder & Elevator

Insert tail wheel into the
rudder then apply instant
glue.
Apply instant type glue
to both sides of each
hinges of the rudder.
Measure the right position
and remove the film from
the stabilizer.

Measure the right position
and remove the cover.
Link the elevator servo to
the elevator with pushrod.
Use the same method to link
the rudder servo to rudder.

Screw four TP screws to
fix up the tail wheel on
the tail of the fuselage.
Install the wheel cover,
and fix it up to landing
gear with TP screw.
Fixup the landing gear
strut to fuselage with 2
bolts.
Install The Landing Gear

The process of fuel tank
installation.
Install the fuel tank into
the fuselage, and fixup it
with belt.
Install the throttle servo
and the throttle rod as
shown.
Install Fuel Tank

Install the engine with
the hook on the engine
equipment.
Install escape-pipe to the
engine as shown.
Canopy installation as shown.
Glow Engine Installation
Assemble The Canopy

Install the cowling with
four TP screws.
Another way to install
brushless motor.

Warning: Never jump this step before flight.
Adjustment

CG & Control surface movement

FINISHED PICTURE